611819
11
Zoom out
Zoom in
Previous page
1/112
Next page
11
EN
Getting Started
Switching Modes
4.
Switch the sensor mode.
By pushing the push switch in the right
transmitter for more than 2 seconds,
the LEDs on the right transmitter blink
green. After conrming the blink,
release the push switch. When the blink
stops, the LEDs on the left and right
transmitters light as follows depending
on the changed sensor mode.
Pedaling monitor mode:
The LEDs light green for 10 seconds.
Power meter mode:
The LEDs light orange for 10
seconds.
For use with Pioneer’s SGX-CA500,
set the sensor mode to pedaling
monitor mode. For use with other
cyclocomputer brands, set the
sensor mode to power meter mode.
Please do not push the push switch
for more than 5 seconds. Doing
so changes the mode to calibrate
the magnet position. Refer to the
Installation Manual for details.
If the pairing between the left and
right transmitters fails, the LEDs
blink red 5 times.
It may take about 10 seconds to
switch the sensor mode depending
on the radio transmission conditions.
5.
Install the right transmitter
cover and tighten the screws
to x it in place.
Use a tool that can measure the torque
to tighten the screws.
Tightening torque: 30 cN·m
Install the transmitter cover and
screw the screws in rmly to ensure
water resistant performance.
11


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Pioneer SGY-PM910H at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Pioneer SGY-PM910H in the language / languages: English, German, Dutch, French, Italian, Spanish as an attachment in your email.

The manual is 0,74 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info