572157
44
Zoom out
Zoom in
Previous page
1/48
Next page
9 Additional Information
44
Incorrect operation can be mistaken for trouble or malfunction. If you think that there is something wrong with this component,
check the points below. Sometimes the trouble may lie in another component. Investigate the other components and electrical
appliances being used. If the trouble cannot be rectified even after exercising the checks below, ask your nearest Pioneer authorized
service station to carry out repair work.
Symptom
Power turns off
abruptly during
operation.
No sound
Can’t switch between
functions.
Play doesn’t start when
the play/pause button
is pressed.
Can’t listen to
broadcasts, or sound is
distorted.
Broadcast is in stereo,
but sound from
speakers is monaural.
Can’t record
Sound is muddy or
distorted. When record-
ing over a previous
recording, the old
recording can still be
heard underneath.
Troubleshooting
Likely Cause
Cooling fan vent is blocked.
The CD receiver has been set on top of soft cloth
or deep-pile rug, thus blocking the cooling vents.
Power plug is disconnected.
Not all connection cables are connected properly.
Unit is in demo mode.
Cassette deck or MD recorder is currently
recording.
Disc has been inserted upside down.
Disc is dirty.
Disc has scratches.
Antenna isn’t connected.
Antenna direction or position is poor.
An electrical appliance (fluorescent lamp, hair
dryer, etc.), including the fluorescent display of
this system, is being used in the near vicinity.
The frequency interval is incorrectly set.
Monaural indicator is lit in the display.
Erasure-prevention tabs are broken out from the
tape cassette.
Heads are dirty.
A type IV (Metal) tape is being used.
Remedy
Install so that the fan is not blocked.
Do not install the CD receiver on top of any
surface that may block the vents.
Connect the power plug correctly.
Refer to the section on connections and make
sure all connections are correct and secure.
To cancel the demo mode, press the power
switch on either of the CD receiver, display
unit, or remote control unit while the demo
mode is operating.
You cannot change the function during
recording.
Load discs with label side (printed surface)
upwards.
Clean the disc.
Use another disc.
Connect antennas properly.
Orient antenna to the proper direction and
position.
Discontinue use of the appliance producing the
noise, or move it farther away from the
antenna.
Adjust the tuning frequency interval correctly
(p.45).
Use the MENU button to select “FM AUTO”
(p.19).
Either replace the tape, or place cellophane
tape over the erasure-prevention tabs (p.6).
Clean the heads (p.46).
Use either a type I (Normal), or Type II (C
r02)
tape.
44


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Pioneer CT-L77 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Pioneer CT-L77 in the language / languages: English as an attachment in your email.

The manual is 1,65 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info