643482
20
Zoom out
Zoom in
Previous page
1/52
Next page
The appliance is designed for connection to an external room thermostat
(not included in the package).
To connect the thermostat use a 2x0.5 mm
2
cable secured with a PG7
cable gland to be inserted in the relative hole in the rear panel (Fig. 30).
Only authorised personnel should carry out this operation.
a Installation can be carried out with any type of room thermostat
but requires a PG7 cable gland similar to that shown in g. 29.
To connect the room thermostat to the electronic board, refer
to the wiring diagram.
To install, proceed as follows:
- Cut off the electricity to the appliance.
- Remove the right side panel (see the paragraph REMOVING THE
CLADDING).
- Remove the knockout to be found in the rear panel (position 4 – Fig.
26).
- Clamp the thermostat cable with the PG7 cable gland and insert the
gland into the hole in the rear panel (Fig. 30).
- Connect the thermostat terminal to the two-pin terminal of the
electronic board (Fig. 28).
- Ret the panel, proceeding in the reverse order to removal.
DT2011598-00
5.2 INSTALLING ThE ExTERNAL ThERMOSTAT
1 Thermostat
2 Electronic board 2-pin terminal
3 Cable gland PG 7
4 Thermostat cable terminal
Fig. 28
1
2
3
4
Fig. 29 Fig. 30
If work has to be carried out inside the cladding, the side panels must
be removed as follows:
- Remove the upper grille [A] after unscrewing the 4 fastening screws
[B]. (Fig. 31)
- Remove the 2 screws [C] that secure the lower front panel [D], lift it
slightly and then pull it outwards to remove. (Fig. 32)
DT2011600-00
5.3 REMOvING ThE CLAddING
A
B
D
C
Fig. 31
Fig. 32
H07029330 / DT2001081 – 02
20
English
DT2032462-00
DT2030076-00 DT2032284-00
DT2032464-00
DT2032465-00
20


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Piazzetta SABRINA at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Piazzetta SABRINA in the language / languages: English as an attachment in your email.

The manual is 2,92 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info