643476
50
Zoom out
Zoom in
Previous page
1/64
Next page
PELLET HOPPER HOUSING TEMPERATURE
Sensor Description Display
Thermostat with
automatic reset
Located on the pellet hopper, its function is to prevent excessive
temperature ranges.
WHEN ACTIVATED
If the pellet hopper temperature reaches critical levels, the thermostat
cuts off the power supply to the fuel-loading auger, thereby stopping the
supply of pellets to the grate and starting the stove shutdown process.
•The readout ‘ALC’ appears in the STOVE STATUS mode.
•After approx. 60 seconds the alarm sounds (if activated).
!
1
TANK TEMP
SAFETY
12:00 73F
WHAT TO DO
Shut down the stove by holding the ON/OFF key down for several seconds.
•The alarm will stop.
•Wait until combustion of any pellets remaining in the grate has nished.
•After having cleaned the grate, restart the stove by pressing the ON/
OFF key. (The readout TANK TEMP SAFETY must no longer appear on
the display. If this is not the case repeat the process described above.)
DT2010995-00
FLUE GAS TEMPERATURE SENSOR
Sensor Description Display
Smoke sensor
Connected to the electronic board, it constantly monitors the working
temperature allowing the stove to be used in all safety.
WHEN ACTIVATED
If the temperature exceeds the xed safety limit the board cuts off the
power supply to the fuelloading auger thus depriving the grate of pellets
and starting the stove shutdown process.
•In the upper part of the display appears the message “SAFETY and in
the lover part appears STOVE”.
•The readout ”MASS TEMP” and the ue gas temperature appear in the
STOVE STATUS mode.
•After approx. 60 seconds the alarm sounds (if activated).
!
!
1
1
SAFETY
STOVE
PROBE
SMOKE
12:00 73F
12:00 73F
WHAT TO DO
•Shut down the stove by holding the ON/OFF key down for several seconds.
•The alarm stops.
•Wait until you are sure that combustion of any pellets remaining in the grate
has stopped.
•Check for and remove whatever has triggered the safety device.
•After having cleaned the grate restart the stove by pressing the ON/OFF key.
Smoke sensor
Disconnected
WHEN ACTIVATED
If the sensor is momentarily or accidentally removed from its normal
position, or is not connected properly to the electronic board, the readout
NO CONN and the ue gas temperature will appear in the STOVE STATUS
mode.
After approx. 60 seconds the alarm sounds (if activated).
!
!
1
1
SAFETY
STOVE
PROBE
SMOKE
12:00 73F
12:00 73F
WHAT TO DO
•Shut down the stove by holding the ON/OFF key down for several
seconds.
•The alarm stops.
•Call the After-Sales Service Centre.
DT2040054-05
H07028100/DT2000970 – 01
50
English
50


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Piazzetta P960 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Piazzetta P960 in the language / languages: English as an attachment in your email.

The manual is 2,34 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info