492013
3
Zoom out
Zoom in
Previous page
1/7
Next page
© 2012 Phoenix Gold • www.phoenixgold.com
INTERNAL BREAKDOWN
High density extruded aluminum heatsink
features 13 grams per mm of mass. Most normal
ampliers have only 6 grams per mm.
Nickel plated panel mount RCA
connections ensure signal purity
and a high quality connection.
Exhaust vents are built into the endcaps.
Airow from the cooling system is pushed
across the internal heatsink ns and
exhausts out these side vents.
High temperature and heavy duty
Tombstone balancing resistors
buer the Sanken output devices.
High current nickel plated buss
bars connections ensure proper
energy transfer.
Ultra low ESR and high energy
secondary capacitors deliver
maximum dynamic performance.
The power supply is loaded with 16 units
of IRF-3205 high current/speed MOSFETs.
They are clamped to the heatsink using
precision aluminum extrusions for dual
heatsinking and lower power supply
operating temperatures.
Legendary Phoenix Gold massive dual
unregulated power supplies are built
for dynamic headroom and to drive
low 1 ohm impedance loads.
Audiophile monolithic signal capacitors
provide frequency response past 50kHz,
well past the ability of human hearing.
Burr Brown op-amps provide ultra low
distortion and maximum resolution in
the pre-amp circuitry.
All crossovers feature aluminum shaft
precision potentiometers with 41 detents
for exact crossover frequency selection.
The dual package Sanken output devices are usually only
reserved for the highest end of home ampliers. They are
more than 12 times faster compared to most competitor’s
output devices (40MHz vs 3MHz). The Sanken devices are
rated at higher power levels, drive lower impedance loads
better and have 2.5 times the surface mounting area to
transfer heat. The end result is the highest possible sound
quality, dynamic performance and reliability.
Power supply transformers are hand
wound and feature a third winding
(nearly all ampliers only have two)
for
higher eciency and lower operating
temperatures.
The fan cooling system is ultra quiet and its speed is
temperature controlled. Air is forced across the internal
heatsink and exhausts out the sides. The end user has
the option to manually control the fan mode via the
endpanel switch.
Clip indicators light when the
amplier reaches maximum
output.
Competitor’s “High End”
125w Output Device
Mid to Low Level
100w Output Device
Elite Dual Package Sanken
200w Output Device
Dual Heatsink
MOSFET Clamp
Note: Elite.4 internals are shown above. Elite.1 and .2 internals will vary.
Subwoofer level control
featuring clip and power
indicators is included with each
Elite amplier.
3


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Phoenix Gold Elite at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Phoenix Gold Elite in the language / languages: English as an attachment in your email.

The manual is 5,16 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info