Notes:
– Operation time will be 8 hours based on the assumption that
the baby unit will be transmitting 25% of the time and is in
standby mode for the rest of the time (baby does not any
make sound).
– When the parent unit batteries are charged for the first time,
operating time will be less than 8 hours.The batteries will use
their maximum capacity after at least four times charging and
discharging.
– Charging will take longer than 16 hours when the parent unit
is switched on during charging.To shorten the charging time,
the parent unit should be switched off.
➜ The parent unit is now ready for use!
Preparing your baby monitor
11
EN
Using your baby monitor
Use this baby monitor for its intended houshold use as described
in this manual.
1 Place both units in the same room to test the connection. Make
sure the baby unit is at least 1 meter /3 feet away from the
parent unit.
2 Press and hold the On/Off (y) button (A-1) on the baby unit for 2
seconds.
> The night light (A-10) lights up briefly.
> The display light (A-11) lights up indicating the current room
temperature.
> The LINK light (A-3) lights up red briefly then starts blinking green as
it seeks connection with the parent unit.If, after 30 seconds,no link is
established, O will appear on the display and the
LINK light starts blinking red as it seeks connection with the parent
unit.
3 Press and hold the On/Off button (y) (B-6) on the parent unit for 2
seconds.
> The sound level lights (B-9) briefly light up orange.
> The display (B-8) lights up.The battery indicator ( ) and the
room temperature light up in the display.
> The LINK light (B-3) lights up red briefly then starts blinking green
as it seeks connection with the baby unit.
> The LINK light (B-3) on the parent unit blinks green and the LINK
light (A-3) on the baby unit blinks red until connection has been
established.This will take up to 30 seconds. Both LINK lights (A-3,
B-3) then light continously green and the message O
will disappear from the baby unit display (A-11).
