368395

Philips scd481 00 Manual

8
Zoom out
Zoom in
Previous page
1/152
Next page
2 Insert four non-rechargeable batteries (Fig. 4).
Note: Make sure the + and - poles of the batteries point in the right direction.
3 Reattach the lid and turn the locking knob clockwise with a coin or screwdriver.
Note: When the batteries are low, the power-on light on the baby unit ashes red.

The parent unit runs on a rechargeable battery pack (included).
Charge the parent unit before you use it for the rst time or when the power-on light on the
parent unit ashes red to indicate that the battery pack is low.
1 Slide the lid of the compartment for the rechargeable pack downwards to remove it (Fig. 5).
2 Insert the plug of the rechargeable battery pack into the socket inside the compartment (1).
Then put the rechargeable battery pack into the compartment (2) (Fig. 6).
Make sure your hands and the unit are dry when you insert the rechargeable battery pack.
3 Slide the lid back onto the parent unit.
4 Place the parent unit in the charger (1), put the small plug in the charger and put the adapter
in a wall socket (2) (Fig. 7).
, During charging, the charging light on the charger lights up red continuously.
5 Leave the parent unit connected to the mains until the battery pack is fully charged.
, When the battery pack is fully charged, the charging light gradually dims.
- When you charge the parent unit for the rst time or after a long period of disuse, switch it
off and let it charge continuously for at least 14 hours.
- When the battery pack is fully charged, the parent unit can be used cordlessly for up to 10
hours.
Note: When the parent unit is charged for the rst time, the operating time is less than 10 hours. The
battery pack only reaches its full capacity after you have charged and discharged it three times.
Note: When the battery pack is low, the power-on light on the parent unit ashes red.
Note: When the battery pack is completely empty, the parent unit automatically switches off and loses
contact with the baby unit.
Note: When the parent unit is not connected to the mains, the battery pack gradually discharges, even
when the parent unit is switched off.

1 Place the two units in the same room to test the connection (Fig. 8).
Make sure the baby unit is at least 1 metre/3 feet away from the parent unit.
2 Press and hold the on/off button 3 on the baby unit until the green power-on light goes
on. (Fig. 9)
3 Turn the volume control to switch on the parent unit and to set the volume to the level you
prefer (Fig. 10).
, The green power-on light goes on.
, The LINK light on the parent unit ashes green until connection has been established.
This takes up to 30 seconds. The LINK light on the parent unit then lights up
green continuously.
Note: If no connection can be established, the LINK light on the parent unit ashes red.
4 Place the baby unit at least 1 metre/3 feet away from your baby (Fig. 11).
8
… 8 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Philips scd481 00 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Philips scd481 00 in the language / languages: English, German, Dutch, Danish, French, Italian, Portuguese, Swedish, Turkish, Spanish, Norwegian, Finnish as an attachment in your email.

The manual is 2,3 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info