Manual Philips N2543 N2544 (page 5 of 51) (English, German, Dutch, Danish, French, Italian, Swedish, Spanish, Norwegian, Finnish)

780731

Zoom out

Zoom in

1/51

(@)

at 'O' as you record.

• You oan check what is

going

onto

the tape by

listening-in during recording

through

headphones

connected to socket ©.

• To suppress the annoying whistle tone which

may

occur when recording stereo radio transmis-

sions,

this recorder is provided

with

pilot-tone

suppression

filter.

When recording such program-

mes,

you can switch on this

filter

by pressing in

switch @. Switch off this

filter

during playback.

• As well as the FM

pilot-tone

suppression

filter,

switch @ is also used for a RIF circuit (Radio

Interference Filter).

This

filter

suppresses whistles

which may occur when recording broadcasts in the

medium or long wave band.

Such

whistles may

occur

particularly when the recorder is stacked

with

other components of a

HIFI

chain, i.e. above or

below a tuner or tuner/amplifier.

The

RIF

circuit operates in

both

positions of switch

if a whistle occurs the switch is pushed to the

other position.

• When making microphone recordings, always

disconnect the other sources

trom

the recorder in

order to avoid undesired mixing of signals. Discon-

nection may be effected e.g. by switching off the

mains

supply of the amplifier when recording

trom

microphone(s) etc.

Similarly,

during the making of other types of

recordings, no microphones must be connected.

prevent unwanted noise being recorded, soek-

ets

not in use should not be touched during

recording.

Recording

• Connect the sound source

from

which you wish

to record to the appropriate socket.

• Insert a cassette.

•

Press

in the corresponding tape selector.

• Switch on the Dolby system, if desired.

•

Press

pause key @.

•

Press

record key @ and start key @ at the same

time.

• The red recording indicator @ now lights.

• Allow the equipment connected to play, or speak

or sing

info

the microphone and adjust the record-

ing level

with

controls

(g)

and

(g)

in such a way that,

during the loudest

passages,

the pointers of the

recording level meters @ and @ deflect just

info

the red

area.

Should the overload indicator @flash

repeatedly, reduce the recording level slightly

with

controls

(g)

and/or@. Differences in the recording

level

between the

left

right

channels can be cor-

rected by setting controls @ and @ to different

positions.

• Now start recording by pressing pause key @.

Check

the recording level

from

time to time and

readjust it (gradually) if

necessary.

• For brief interruptions press pause key @.

• To stop, press stop key @.

• For fast rewinding press rewind key @. For tast

winding, press wind key®. To stop, press stop key

©•

Playback

The

recordings made can be reproduced

through

headphones and/or

through

an amplifier/speaker

system.

• Connect the headphones and/or an amplifier to

the appropriate socket (see 'Connecttons').

• Set the amplifier for recorder playback.

• Insert a recorded cassette.

•

Press

the corresponding tape selector.

• Switch on the Dolby system, if

necessary.

•

Press

start key @.

• Adjust the volume, tone and balance on the

amplifier.

• The volume when playing back via headphones is

constant.

• To stop, press stop key @.

N.B.:

During playback, the pointers of the meters@

and @ will deflect in the same manner as they did

during recording.

Depending on the kind of tape in the cassette which

used,

the deflection during playback may differ

from

the deflection when the same part was

recorded.

This

has no influence on the quality of the

sound.

See also 'Introduction to recording'.

Review

and cue

This

recorder incorporates a special mechanism

which offers the possibility to switch over

from

recording or playback to fast rewind or fast wind

directly

without

stopping the tape in between.

• After a recording:

Press

one of the

keys

@ or @

until

the desired part of the recording has been

located

with

help of counter @.

After releasing the pressed key, the recorder

changes

over to playback automatically, because

the record key disengages when pressing one of

the

keys

@ or @.

• During playback:

Press

one of the

keys

@ or @

until

the desired part of the recording has been

located.

After releasing the pressed key, the

recorder starts to playback again automatically.

Maintenance

The

audio quality can be adversely affected by the

dust and grime which tend to accumulate on the

magnetic heads. It is therefore advisable to clean

the heads

from

time to time, for which purpose we

recommend our special cleaning cassette, type

811/CCT.

The cassette, which is played

through

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Philips N2543 N2544 in the language / languages: English, German, Dutch, Danish, French, Italian, Swedish, Spanish, Norwegian, Finnish as an attachment in your email.

The manual is 18.71 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Philips N2543 N2544 Manual

Product: