445486
28
Zoom out
Zoom in
Previous page
1/34
Next page
>
Switch off and disconnect the projector before cleaning.
1 Press the Standby button twice to switch off the projector.
The Standby indicator starts blinking orange.
2 Wait until the cooling fan has stopped (about 3 minutes after the projector has been put in
Standby) and disconnect the mains lead and all other cables.
Cleaning the cabinet
When the cabinet is dusty, clean it by gently wiping with a soft cloth.
A chamois leather slightly moistened with water is sufficient for cleaning the housing.
Do not use cleaning agents as they may harm the housing.
Cleaning the lens
When the lens is dirty or dusty, first blow the dust off and then gently wipe with a soft
brush or lens cleaning paper. Never touch the lens with your fingers.
The lens is likely to become mouldy if left dirty.
Cleaning the dust filter
Make sure to clean the dust filter regularly.
1 Switch off the projector and wait until the cooling fan has stopped before disconnecting the
projector.
2 Turn the projector over. Never place the projector on the side where the connections are
located!
3 Press tab A and remove filter holder B from the projector.
4 Press clamp C, open the holder and remove the filter.
5 While firmly holding the filter, gently remove any accumulated dust, from the dusty side, with
a vacuum cleaner.
6 Press clamp C, put the filter back in place and release clamp C. Firmly press the filter edges
in place.
7 Close the filter holder.
8 Press tab A and insert the filter B into the projector.
We advise you to clean the filter every 100 hours. Operating the projector without filter or with a torn
or damaged filter may seriously damage the projector.
When the filter is damaged replace it with a filter of the same type (12 nc: 3122 434 0157 0).
The projector power cannot be switched on again unless the filter holder is installed correctly.
Cleaning
Caution
Important
Notes
Philips Multimedia Projector 28 English User guide bSure1 / bSure 2
6. Maintenance
A
B
C
C
A
B
Menu OK
AV
Mute
Source
Stand
by
Lamp
Temp
Menu OK
AV
Mute
Source
Stand
by
Lamp
Temp
28


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Philips bSure 2 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Philips bSure 2 in the language / languages: English as an attachment in your email.

The manual is 2,35 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info