445486
33
Zoom out
Zoom in
Previous page
1/34
Next page
Lamp indicator
green: normal lamp condition.
orange: lamp life has almost expired (less than 100 hours to go).
See warning messages on the start up screen for details.
red: lamp life has expired.
Replace lamp. See Maintenance.
red (fast blinking): lamp start has failed.
Disconnect projector from the mains. Reconnect and restart. If this does not resolve the
problem, replace the lamp. See Maintenance.
Temperature indicator
red: temperature error.
The projector will go into Power/Standby mode. Allow the projector to cool down;
this may take up to 30 minutes. When the LED goes out press any button to activate the
projector again.
fast blinking red: fan error.
The projector will go into Power Standby mode. Make sure the filter cover is closed
properly; clean air inlets or dust filter and allow the projector to cool down; this may take
up to 30 minutes.When the LED stops flashing press any button to activate the projector
again.
Standby indicator (text on Standby button/ring around Standby button)
red: standby mode.
green: operation mode.
orange: warming up.
slow blinking (orange): cooling down.
Do not switch the projector off; it will restart the lamp automatically within a few seconds.
–’Monitor out has been enabled, but the external monitor is not correctly connected (the picture
on both displays is too bright).
Connect the (optional) VGA Y-cable (See Connecting to an external monitor under
Installation).
If the VGA Y-cable is correctly connected, verify whether the input impedance of the monitor
is correctly set on 75 Ohm.
–’Monitor out has not been enabled, but the external monitor is connected
(the picture on both displays is too dark).
Enable the Monitor out option. Press Menu and use cursor control to go to Settings in the
menu bar. Select Monitor out and select On.
–’Keylock active.
Press OK for 10 seconds to cancel Keylock.
Indicators
Picture too dark or bright
with external monitor
connected
No reaction when pressing
keys on local keyboard or
remote control
Philips Multimedia Projector 33 English User guide bSure1 / bSure 2
7.Troubleshooting >
33


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Philips bSure 2 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Philips bSure 2 in the language / languages: English as an attachment in your email.

The manual is 2,35 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info