770982
9
Zoom out
Zoom in
Previous page
1/28
Next page
9
petsafe.com
Step 3: Design Your Boundary Zone
Basic Planning Tips
Always design your layout, position the
boundary wire and test the system as outlined in
this product manual before burying the boundary
wire. You do not want to find out after burying the
wire that there is a problem with your layout or a
loose connection somewhere.
Sample layouts are provided in this section.
The boundary wire must start at the fence
transmitter and make a continuous loop
back (3A).
Always use rounded corners with a minimum 3 ft.
radius to produce a more consistent boundary
(3B). Do not use sharp turns; this will cause gaps
in your boundary.
Create areas in your yard that allow your pet
to safely cross over the boundary wire without
static correction by twisting the boundary
wires together 10 to 12 times per foot (3C). This
transmission cancels the signal and allows your
pet to safely cross over that area.
To properly contain your pet, we recommend
setting a boundary width for the warning
and static correction zones to approximately
12–20 ft. (6 to 10 ft. on each side of the wire).
Avoid making passageways too narrow for your
pet to move about freely (e.g., along the sides of
a house).
The receiver collar can be activated inside the
house if the boundary wire runs along the outside
wall of the house. If this occurs, remove your
pet’s receiver collar before bringing him inside,
decrease the range using the boundary width
control knob or consider an alternate layout.
3A
3B
9


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Petsafe PUL-275 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Petsafe PUL-275 in the language / languages: English as an attachment in your email.

The manual is 3.06 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info