770986
18
Zoom out
Zoom in
Previous page
1/24
Next page
18 +1 (800) 732-2677
Wireless-to-Go
Your PetSafe® Stay & Play Compact Wireless Fence system is completely portable. Follow the setup procedures (Steps 1
through 4) wherever you wish to have containment of your pet. Reestablish the pet area and mark it with boundary flags so
your pet knows his boundary zone. Place the transmitter indoors at least 3 feet from large metal objects.
Note: If setting up in a metal building or vehicle, the maximum size of the pet area may be reduced. Be sure to remove
the receiver collar before removing power from the transmitter. If you want to power the transmitter from a car or other
DC source, use an inverter rated for 50 watts or more.
Troubleshooting
The transmitter
is sounding an
intermittent double
tone alarm.
The intermittent double tone is the metal interference alarm. This alarm sounds if
the transmitter is placed too close to a metal surface. When this alarm sounds,
the transmission output is disabled and your pet is no longer being contained.
Relocate the transmitter and either unplug the power adaptor from the power
jack or press the alarm disable button for 5 seconds then release.
The transmitter is
sounding a intermittent
single tone when I
unplug the power
adaptor from the
wall outlet.
The power loss alarm in the transmitter is activated to alert you that power has
been removed from the transmitter and your pet is no longer being contained.
To turn off the power loss alarm, unplug the power adaptor from the power jack
located on the bottom of the transmitter or press the alarm disable button for
5 seconds then release.
The transmitter is
generating a loud
continuous tone.
The transmitter has a built in transmission failure alarm that continuously monitors
the transmitter output. If a transmission failure ever occurs the alarm warns you that
your pet is no longer being contained. Contact the Customer Care Center for a
replacement transmitter.
The receiver collar
tone is not sounding
when setting up the
boundary zone.
Make sure the receiver collar is turned on and battery status lights are flashing
every 4-5 seconds.
Charge receiver collar.
The tone may be difficult to hear in a noisy environment.
Use test light as explained in the “test light instructions” section, and use it to
determine the location of boundary zone.
Check that the transmitter is set up according to directions.
The receiver collar
tone is not sounding or
administering a static
correction.
Make sure receiver collar is turned on and battery status lights are flashing every
4-5 seconds.
Charge receiver collar.
Check that the transmitter is plugged into a working 120 volt outlet, the power light
is on, and the transmitter controls are set at your desired settings.
The receiver
collar tone is
sounding everywhere.
Check that the transmitter is plugged into a working standard 120 volt outlet, the
power light is on, and the transmitter controls are set at your desired settings.
Bring the receiver collar within 10 feet of the transmitter to reset.
Make sure no continuous alarm is sounding on the transmitter.
18


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Petsafe PIF00-14288 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Petsafe PIF00-14288 in the language / languages: English as an attachment in your email.

The manual is 1.79 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info