770986
8
Zoom out
Zoom in
Previous page
1/24
Next page
8+1 (800) 732-2677
Transmitter Alarms
The transmitter has three built-in warning alarms:
Power loss alarm
Metal interference alarm
Transmission failure alarm
Power Loss Alarm
The power loss alarm sounds an intermittent single tone alarm indicating power has been removed from the transmitter.
The power loss alarm will last up to 30 minutes. In the event of a power loss, your pet is no longer contained.
There are three ways to turn off the power loss alarm.
1. Plug the adaptor into a functional 120 volt outlet.
2. Unplug the transmitter power adaptor from the power jack located on the bottom of the transmitter.
3. Press the alarm disable button for 5 seconds then release. Three short tones will sound to signify the alarm has
been turned off.
Metal Interference Alarm
The metal interference alarm sounds an intermittent double tone alarm indicating that the transmitter has been set
towards the maximum range and placed on or close to a metal surface. If the metal interference alarm sounds, your pet
is no longer contained. You must relocate the transmitter away from metal or the alarm will continue to sound and the
transmission from the transmitter will remain disabled.
There are two ways to turn off the metal interference alarm and re-initiate the transmitter radio signal.
1. Unplug the transmitter power adaptor from the power jack located on the bottom of the transmitter.
2. Press the alarm disable button for 5 seconds then release.
Transmission Failure Alarm
The transmission failure alarm makes a continuous tone indicating a transmitter problem. In this situation, your pet can no
longer be contained. Contact the Customer Care Center for a replacement.
Step 2: Charge the Receiver Collar
The receiver collar charger is designed to plug into a standard AC wall outlet. The receiver collar light will glow red
when the receiver charger is properly seated into the receiver charge jack. The light will turn green when charging is
complete. A built-in safety circuit prevents the receiver collar from overcharging.
The receiver collar will achieve a full charge in 2–3 hours. Each charge can last up to 3 weeks depending upon
frequency of use.
Do not charge your receiver collar every night. Frequent charging can have a negative effect on
the battery. We recommend that the receiver collar be used until the receiver indicator light blinks
yellow or red.
Receiver
Charge
Jack
Contact
Point
Mode
Button
Receiver
Indicator
Light
8


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Petsafe PIF00-14288 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Petsafe PIF00-14288 in the language / languages: English as an attachment in your email.

The manual is 1.79 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info