24
The powder cartridge (optional accessory) is free of any powder residue.
The quality of the crema The best crema quality will only develop after the appliance has been in use
is insufficient for some time.
Routinely decalcify and clean the filter insert (19). Observe the information in
section “Cleaning and Care”.
The two filters in the filter insert (19) may not be pushed together. However, if
this has occurred, it must be replaced.
The outlet drips for Always set the rocking lever (5) to after brewing, this prevents lengthy
a long time post-dripping.
The appliance switches off The appliance may not be operated in locations, which are more than 1,500 m
during heating above sea level.
Milk is not suctioned due Wait until the start/stop button (12) is again illuminated in green and attempt
to the lack of steam the process a second time.
Clean the steam nozzle (23) as described in section “Cleaning and Care”.
Milk froth splatters and is Push the tube adapter (26) up to the stop into the mixer (27) so that no gap is
very porous visible at the handle. Twisting the tube adapter will not result in any changes.
The frothed milk does not Clean the professional milk frothing unit.
have sufficient foam Remove contaminations on the air duct (29) of the tube adapter (26). Check if
its opening is open. A tube adapter (26) with a damaged air duct (29) must be
replaced.
Use cold milk, directly from the refrigerator.
Milk froth runs continuously The milk suctioning cup (31) should be at least 14 cm tall, otherwise the
suctioning cup (31) could be suctioned empty after frothing (siphon effect).
Do not hang the tube (25) directly into a 1 liter Tetra pack.
The decalcification program It is important that both buttons are pressed simultaneously. If you press one
does not start button earlier, the decalcification program will not start. Try it again and only
release the buttons shortly after the pump starts.
Water escapes on the Check if the pad is properly located in the pad cartridge (6). If the paper edge
handle of the pad cartridge projects over the edge of the depression, the seal will no longer seal during
brewing.
Water is located under Empty the drip pan (8) in time.
the appliance Only fill the water tank (4) up to the max mark.
Never let the appliance stand over an extended period without the water tank (4).