807439
3
Zoom out
Zoom in
Previous page
1/8
Next page
388_VENEZIA_21/02/18 Copyright © 2014 Peruzzo Italy - MADE IN ITALY3/8
Assemblare le cinghie sul portabici come da
2a
e
2b
,
facendo attenzione al giusto verso di entrata
nella fibbia
3
, e al corretto posizionamento delle
cinghie F1 superiori, F2 laterali (se presen-
ti), F3 inferiori,
4
. Verificare la tenuta delle cinghie
strattonandole.
Attenzione
Prima dell’assemblaggio delle cinghie, consultare la
lista adattabilità auto a disposizione nel punto vendita
e verificare la necessità dell’utilizzo dell’adattato-
re I. La lista specifica il numero e la posizione
( F1-F2-F3 ) che l’eventuale adattatore I deve avere
sulla vostra auto. Se l’adattatore I non è incluso nella
confezione del portabici, acquistarlo separatamente
presso il rivenditore. Una volta determinato lo schema
di montaggio dell’eventuale adattatore I, montarlo
in sostituzione del gancio G,
2a
e
2b
.
MONTAGGIO CINGHIE
Assemble the straps on the bicycle carrier as shown in
2a
and
2b
, paying attention to the correct direc-
tion, of entry in the buckle
3
and correct position-
ing of the upper straps F1, side straps F2 (if pre-
sent), and lower straps F3,
4
. Check the hold of the
straps by pulling on them.
Important:
Before fitting the straps, consult the car adaptability
list available at the sales outlet and check if adapt-
er I has to be used. The list specifies the number and
the position ( F1-F2-F3 ) that the possible adapt-
er I must have on your car. If adapter I is not includ-
ed in the bicycle carrier package, purchase one sepa-
rately from the dealer. After establishing the assembly
layout of the possible adapter I, fit it in place of the
clasp G,
2a
and
2b
.
FITTING THE STRAPS
Ensamblar las correas en el portabici como en fig.
2a
y
2b
, poniendo atención en la manera correcta de
introducirlas en la hebilla
3
, y en el correcto posi-
cionamiento de las correas F1 superiores, F2 latera-
les (si están), F3 inferiores,
4
. Verificar que las correas
estén firmemente sujetas, tirando de las mismas
Atención
Antes de ensamblar las correas, consultar la lista de
adaptabilidad al coche, disponible en el punto venta y
comprobar si es necesario utilizar el adaptador I. La
lista especifica el número y la posición ( F1-F2-F3 )
que el eventual adaptador I debe tener en tu coche.
Si el adaptador I no viene incluido en la confección
del portabici, puedes adquirirlo por separado en el
punto venta. Una vez determinado el esquema de
montaje del eventual adaptador I, montarlo en susti-
tución del gancho G,
2a
y
2b
.
MONTAJE CORREAS
I GB E
MONTAGGIO PORTACICLO
1. Se necessario, seguire la figura
5
per assemblare
i bloccabici L al tubo D e la figura
5a
per fissare
gli appoggi in gomma P.
2. Controllare il perfetto avvitamento di bulloni e dadi
di assemblaggio, eventualmente avvitarli nuova-
mente.
3. Regolare archi e braccia con la triangolazione che
più si avvicina alla sagoma della vostra auto, come
da esempi forniti in
6
7
8
9
e consultare
la lista adattabilità auto.
4. Le braccia reggiciclo devono essere regolate con
un’angolazione minima di 10 gradi verso l’alto,
rispetto al piano orizzontale,
6
7
8
9
5. Bloccare fortemente i rocchetti con il pomello (o la
leva, a seconda del modello) e assicurarsi che i denti
siano perfettamente accoppiati, figure
10
10a
BICYCLE CARRIER INSTALLATION
1. If necessary, follow figure
5
to assemble the
bicycle clamps L on pipe D and figure
5a
for
fixing the rubber supports P.
2. Check the perfect tightness of the assembly bolts
and nuts, and retighten if necessary.
3. Adjust the bars and arms with a triangulation as
close as possible to the shape of your car, as shown
in the examples provided in
6
7
8
9
and
consult the car adaptability list.
4. The bicycle support arms must be adjusted with
an upward angle of at least 10 degrees to the hori-
zontal,
6
7
8
9
.
5. Tighten the sprockets hard with the knob (or the
lever according to model) and make sure the teeth
are perfectly coupled,
10
10a
.
MONTAJE PORTABICI
1. Si necesario, seguir la figura
5
para ensamblar los
bloqueadores de la bici L al tubo D y seguir la figura
5a
para sujetar los soportes de caucho P.
2. Controlar el perfecto atornillado de pernos y de tuercas
de ensamblaje, y si fuera necesario, atornillarlos de
nuevo.
3. Regular arcos y brazos con la triangulación que más se
asemeje al perfil de tu coche, como se explica en las
6
7
8
9
y consultar la lista de adaptabilidad
al coche.
4. Los brazos que sostienen la bici se tienen que regular
con un ángulo mínimo de 10 grados hacia arriba, con
respecto al plano horizontal,
6
7
8
9
.
5. Bloquear firmemente los carretes con la perilla (o la
palanca, según el modelo) y comprobar que los dientes
estén perfectamente acoplados,
10
10a
6789
1
2
3
10 10a
OKOK
3


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Peruzzo Venezia 388 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Peruzzo Venezia 388 in the language / languages: English, French, Italian, Spanish as an attachment in your email.

The manual is 9.22 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Peruzzo Venezia 388

Peruzzo Venezia 388 Additional guide - All languages - 28 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info