742525
10
Zoom out
Zoom in
Previous page
1/57
Next page
8
GB
Operating your radio-FM/AM auto-tune
1. Straighten up the antenna.
2. Press the Power button to switch on your radio.
3. Press the Source button until the FM/AM band is selected.
4. Rotate the Tuning control in a clockwise direction. The displayed frequency will increase. Then
press the Tuning control to carry out an auto-tune. Your radio will scan up the FM/AM band
from the currently displayed frequency and will stop scanning when it nds a station of sufcient
strength. To scan down in frequency, rotate the Tuning control in an anticlockwise direction rst
and then press the Tuning control. Your radio will scan down the FM/AM band from the currently
displayed frequency and will stop scanning when it nds a signal of sufcient strength.
5. After a few seconds the display will update. The display will show the frequency of the signal
found.
6. To find other stations press the Tuning control as before. When the end of the waveband is
reached, your radio will recommence tuning from the opposite end of the waveband.
7. Adjust the Volume to the required setting.
8. To switch off your radio, press the Power button.
Note:
If you nd the reception is poor, try repositioning the antenna.
Manual Tuning-FM/AM
1. Press the Power button to turn on the radio.
2. Select the required waveband by pressing the Source button.
3. Be sure to screw in the rubber FM antenna properly to get best reception. For AM (MW) band,
rotate the radio to get best signal.
4. Rotate the Tuning Control knob will change the frequency in the following increments
FM: 50 or 100 kHz
AM (MW): 9 or 10 kHz (10 kHz setting for AM band in North America)
5. Rotate the Volume Control knob to get required sound level.
6. To turn off the radio, press the Power button. Display will show OFF.
Memory presets stations-FM/AM
Storing stations in preset memories, please follow below step. There are 5 memory presets for each
waveband.
1. Press the Power button to turn on the radio.
2. Tune to required station by pressing the Source button and the Tuning control.
3. Press and hold down the required preset until the preset number stops flashing until the radio
beeps. The preset number will appear in the display and the station will be stored under chosen
preset button.
4. Repeat this procedure for the remaining presets.
5. Stations stored in preset memories can be over written by following above procedures.
10


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for PerfectPro TBox2 - TOUGHBOX 2 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of PerfectPro TBox2 - TOUGHBOX 2 in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 3,57 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info