446687

Pelgrim PK654 Manual

14
Zoom out
Zoom in
Previous page
1/21
Next page
27
3 Position and arrangement
26
When you use pans on the back zones, make sure the pan does not stand on or •
touch the profile of the glass decorative lid. Keep a distance of at least 2.5 cm
between the profile and the pan; otherwise the profile might get damaged.
The glass cover may break as a result of heat. Check that all the cooking zones/hot •
plates have been switched off and have cooled down before you close the cover.
2.2 What you should pay attention to (ceramic hob)
The cooking zones get very hot during use and also remain hot for some time after •
use (see also ‘residual heat indication’). Do not allow small children in the vicinity of
the hob during and soon after cooking.
The glass-ceramic cooking surface is very strong but not unbreakable. A breakage •
may occur if a sharp object falls on it.
Do not use the hob as a work surface for cutting meat or vegetables, for instance. •
Do not continue to use an appliance whose cooking surface is showing a break or •
cracks. Switch the appliance off immediately. Remove the plug from the socket or
set the switch of the power supply cable (in the case of a fixed connection) to zero or
turn off the fuse switch(es) in the meter cupboard. Phone the service department.
Aluminium trays or foil are not suitable as cooking utensils. •
2.3 What you should pay attention to (electric hob)
The hot plates get very hot during use and also remain hot for some time after use. •
Do not allow small children in the vicinity of the hob during and soon after cooking.
Turn the mains voltage off during cleaning and maintenance by unplugging the plug •
from the socket or by switching off the circuit-breaker in the meter cupboard.
Never use the hot plates without any pans on it. •
Never put aluminium foil directly onto the hot plates. •
Remove spills as quickly as possible. Spills caused by boiling over of dishes such as •
red cabbage, rhubarb and apple sauce in particular must be removed immediately.
If they remain on the enamel or stainless steel surface for too long, the surface may
discolour.
Moisture on the cooking surface may cause rust. •
2 Safety
3.1 General
This appliance complies with all the relevant CE directives. •
On the label on the back of this equipment, you will find the total wattage, the •
required voltage and the frequency.
3.2 Placing
Install the hob on a flat, stable and horizontal base. •
Keep a free space of at least 2 cm around the hob. •
After installation, the socket or switch (in case of a fixed connection) must always be •
accessible.
The walls around the appliance must be made of heat resistant (>85°C) material. •
Even if the appliance itself does not get hot, the heat from a hot frying pan for
instance could cause discolouring or damage to the walls.
Ensure that the power cord will not become in contact with parts that can become hot. •
Do not place any inflammable or deformable objects directly beneath the hob. •
3.3 Safety
This appliance should only be connected up by a registered electrical installer! The •
electrical connection must comply with national and local regulations. The appliance
should always be earthed. Damage caused by incorrect connection or incorrect use is
not covered by the guarantee
3.4 Electrical connection
The electric hob is connected according to diagram 230 V 2Nac (see the diagram •
at the bottom of the appliance). If another connecting is required, let a registered
electrical installer made the connection.
The connection terminals are accessible once you have opened the connection box •
on the underneath of the appliance. The connection box cover can be opened with
a screwdriver. You can use the bridges provided in the connecting box to make the
required interconnections.
If you want to make a fixed connection, make sure that a multi-polar switch with a •
contact separation of at least 3 mm is fitted in the supply line.
The power cord is a type Y. This means that the power cord may only be replaced by •
the manufacturer, the manufacturer’s service organisation or equivalently qualified
persons, in order to avoid dangerous situations.
… 14 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Pelgrim PK654 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Pelgrim PK654 in the language / languages: English, Dutch as an attachment in your email.

The manual is 1,4 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info