446687
19
Zoom out
Zoom in
Previous page
1/21
Next page
36
37
5 The electric hob 5 The electric hob
5.3.3 Elements
Wiping with a kitchen towel is usually sufficient.
Remove boiled over and burnt leftovers with the blunt side of a knife or a non-
abrasive sponge (Scotch Brite no. 373).
Always remove any remaining soap after cleaning and switch on the elements for a
short while to evaporate the humidity.
Rub the plates every now and then with acid free oil (sewing machine oil) or with a
maintenance product Collo Elektrol (drugstore).
5.3.4 Stainless steel rim
The stainless steel rim along the elements can be cleaned with a non-abrasive
sponge (Scotch Brite no. 373). Remove the remains of the soap after cleaning,
especially between the cast iron element and the stainless steel rim.
5.3.5 Decorative glass cover
Always clean the decorative glass cover after use. If the lid is very dirty we advise you
to soak the decorative glass cover in water with a bit of dishwasher detergent for a
while (e.g. by putting a humid cloth on top of the glass cover).
Removing the decorative glass cover
Open the decorative lid. Carefully lift the decorative º
glass cover out of the hinged brackets.
Placing the decorative glass cover
Carefully lower the decorative glass cover into the º
hinged brackets. The decorative lid must only be
placed vertically (see illustration). If this does not work,
then the hinges need to be replaced. Never randomly
switch the location of the hinges, because if they are
wrongly located, then the lid cannot be brought to
a standstill and it can drop down. Attention! Always
check if the decorative lid can be brought to a standstill
after re-installing it. Close the decorative glass cover.
5.4 Faults
If the appliance does not work properly, this does not always mean that it is defective.
Try to deal with the problem yourself first. Phone the service department if the advice
given below does not help. Only authorised personnel may open the appliance or carry
out work on the mains power supply. Damage caused by incorrect connection, incorrect
installation or incorrect use is not covered by the warranty. In the case of faults visit the
internet site ‘www.atagservice.nl’.
FAULT CAUSE SOLUTION
Hot plates do not get hot. Plug not, or not completely,
in the socket.
Fuse(s) in the meter
cupboard defective.
Put the plug into the socket.
Check the fuses in the
meter cupboard.
19


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Pelgrim PK654 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Pelgrim PK654 in the language / languages: English, Dutch as an attachment in your email.

The manual is 1,4 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info