Manual Pelgrim GVW 592 (page 72 of 79) (English, German, Dutch, French)

78021

Zoom out

Zoom in

1/79

If you decide to turn back to the use of

standard detergent system we advise

that you:

1. Fill up the dispensers for salt and rinse aid

again.

2. Adjust the water hardness setting to the

highest setting and perform 1 normal

washing programme without loading any

dishes.

3. Adjust the water hardness setting ac-

cording to the hardness of the water in

your area.

4. Adjust the rinse aid dosage.

Select and start a washing programme

Select the washing programme with

the door slightly opened. The start of

the programme will occur only after

the closure of the door. Until then it

is possible to modify the settings.

1. Check that the baskets have been loaded

correctly and that the spray arms are free

to rotate.

2. Check that the water tap is opened.

3. Press the on/off button. The appliance

must be in setting mode.

4. Press the programme selection/cancel

button until the light corresponding to the

required washing programme comes on

(see 'Washing programmes' chart).

Close the appliance door, the pro-

gramme starts automatically.

Setting and starting the programme with

delay start

The start of the washing programme will

be delayed by 3 hours.

1. Select a washing programme.

2. Press the delay start button. The corre-

sponding indicator light comes on.

3. Close the appliance door. The count-

down starts automatically.

Opening the door will interrupt the

countdown. Once the door is closed the

countdown will continue from the point

at which it was interrupted.

4. Once the countdown has elapsed the

washing programme will start automati-

cally.

Cancel a delay start in progress

1. Open the appliance door.

2. Press the delay start button. The corre-

sponding indicator light goes off.

3. Close the door. The washing programme

will start automatically.

Warning! Interrupt or cancel a

washing programme in progress

ONLY if it's absolutely necessary.

Attention! Hot steam may escape

when the door is opened. Open the

door carefully.

Interrupt a washing programme in

progress

Open the appliance door; the programme will

stop. Close the door; the programme will

start from the point at which it was interrup-

ted.

Cancel a washing programme in

progress

• Open the appliance door; press the pro-

gramme selection/cancel button for about

3 seconds, until the light of the running

programme goes off and the end of pro-

gramme indicator light flashes. The wash-

ing programme has been cancelled and

the appliance is now in setting mode.

• If a new washing programme is to be se-

lected, check that there is detergent in the

detergent dispenser.

End of the washing programme

• The appliance will automatically stop and

an audible signal informs you of the end of

the washing programme.

• Open the appliance door.

• The end of programme indicator light is on.

• The indicator light of the programme just

ended remains on.

1. Switch off the appliance by pressing the

on/off button.

2. Leave the appliance door ajar and wait a

few minutes before removing the dishes;

in this way they will be cooler and the dry-

ing will be improved.

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Pelgrim GVW 592 in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 6,55 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Pelgrim GVW 592 Manual

Product: