773682
24
Zoom out
Zoom in
Previous page
1/62
Next page
MY20P02-2_1.0_13.01.2020 24
Assembly
2Push in the quick release until you can hear a
click. Make sure that the flange is extended.
Figure 24: Pushing the quick release in
3Adjust tensioning with half-open clamping
lever until the flange reaches the fork end.
Figure 25: Adjusting the clamping
4Fully close the quick release. Check that the
quick release is firmly in place and adjust it on
the flange if necessary.
The lever is secured.
Figure 26: Closing the quick release
5.3.2 Installing the wheel in the FOX fork
5.3.2.1 Quick release (15 mm)
Only applies to FOX forks with 15 mm screw-on axle
The procedure for installing the 15 x 100 mm and
15 x 110 mm quick releases is the same.
1Place the front wheel in the fork ends of the
fork. Push the axle through the fork end on the
non-drive side and hub.
Figure 27: Pushing the quick release in
2Open the axle lever.
3Turn the axle five to six complete revolutions
clockwise into the axle nut.
4Close the quick release lever. The lever must
be tensioned to the point that it leaves a mark
on your hand.
5The lever must be 1 to 20 mm ahead of the fork
leg in the closed position.
Figure 28: Spacing between lever and fork leg
The quick release must be adjusted if the lever
is tensioned inadequately or too strongly when
closed in the recommended position (1 to
20 mm in front of the fork).
1-20 mm
24


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Pegasus 2020 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Pegasus 2020 in the language / languages: English as an attachment in your email.

The manual is 7.1 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Pegasus 2020

Pegasus 2020 User Manual - German - 66 pages

Pegasus 2020 User Manual - Dutch - 63 pages

Pegasus 2020 User Manual - French - 65 pages

Pegasus 2020 User Manual - Italian - 65 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info