576663
14
Zoom out
Zoom in
Previous page
1/110
Next page
14 GB/IE
Using the product
Q
Solder sponge
CAUTION! The hot soldering tip
7
must never be placed in
contact with a dry solder sponge
5
, otherwise the solder sponge
may be damaged.
The solder sponge
5
is used to clean soldering tips.
Moisten the solder sponge
5
before you use it.
Q
Soldering
If inhaled, vapours may cause headaches and fatigue as
well as other symptoms.
The soldering pencil has a rated output of 48 watts and is therefore
ideal for electronics soldering (see Figs. A, B).
The design of the soldering pencil makes it especially suitable for
use where access is difficult or for fine soldering work.
Clean the soldering tip
7
on the moist solder sponge
5
.
After cleaning the tip
7
it must be “tinned” (coated with solder).
This is done by melting solder on to the hot soldering tip
7
.
Guide the soldering tip
7
to the intended joint site and heat the joint.
Place the solder (with flux) between the joint site and the tip
7
to melt it.
Continue to feed further solder until the whole joint has a covering
of solder.
Then quickly remove the soldering tip in order to avoid overheating
the molten solder.
Allow the solder to harden while not subjecting it to vibration or
movement.
Note: The flux is either already contained in the solder or applied
separately.
… / Maintenance and cleaning / Service centre
14


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Parkside PLBS 48 B1 - IAN 102652 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Parkside PLBS 48 B1 - IAN 102652 in the language / languages: English, German, Dutch, Danish, French, Swedish, Finnish as an attachment in your email.

The manual is 0,9 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info