773449
20
Zoom out
Zoom in
Previous page
1/72
Next page
GB/IE 21
Off Position If the heating level switch
2 is in this position, the
fan heater is switched off.
Fan position If the heating level switch
2 is in this position, only
the fan operates. Move
the switch to this position
when you want to use the
heater as a fan.
Heat control
setting 1
If the heating level switch
2 is in this position, the
fan heater produces a
heat output of 1000 W.
Heat control
setting 2
If the heating level switch
2 is in this position, the
fan heater produces a
heat output of 2000 W.
Note: The heater requires about 8 minutes to warm up.
Setting the Temperature
Start the heater by using the heating level switch
2 to set the desired heat level.
Turn the temperature control 4 clockwise until it
stops. The control light 3 begins to illuminate.
When the desired temperature is reached, turn
the temperature control 4 counter-clockwise
until you hear an audible click, the control light
3 will then go out. An integrated thermostat
will now automatically switch the heating func-
tion on and off. The fan continues to run continu-
ously during this time.
Please note: The fan heater temporarily remains very
hot during the heating intervals. Please take care when
operating the fan heater.
The fan heater has angle adjustment. Turn the rotary
knobs
6
at the side to adjust the tilt.
Switching off the Fan Heater
To avoid heat build-up in the fan heater, allow the
fan to run for approximately 2 minutes afterwards.
Turn the temperature control 4 back to MIN.
Turn the heating level switch 2 to position 0.
Pull out the mains plug to disconnect the heater from
the mains supply, thus switching it off completely.
Overheating Protection
This fan heater is equipped with overheating pro-
tection. If the fan heater overheats, it will switch off
automatically. The fan continues to run so that rapid
cooling is achieved. The fan heater will switch on
again automatically once it has cooled down properly.
PLEASE NOTE: There is usually a reason for
overheating! It can indicate a fire hazard!
Check whether the fan heater is giving off suffi-
cient heat: Is the fan heater covered or is it too
close to a wall or other obstruction? Is the grid
blocked in the front or at the back? Is the fan
blocked?
Rectify the problem if possible, or contact the ser-
vice hotline (see the section “Service”).
Even if you were unable to identify the cause, if
the overheating protection is triggered a second
time, you must switch off the fan heater and con-
tact the service hotline (see “Service” Section).
20


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Parkside PKH 2000 A1 - IAN 320136 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Parkside PKH 2000 A1 - IAN 320136 in the language / languages: English, German, Dutch, French, Polish as an attachment in your email.

The manual is 1.82 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info