819956
31
Zoom out
Zoom in
Previous page
1/186
Next page
GB
MT
31
damaged parts. Ensure that the screws
in the safety cutter bar (2) are firmly in
place.
Check the covers and protective
devices (1/3) for damage and correct
fit. Replace these if necessary or have
them repaired by the service centre.
You can smooth out slight nicks on the
cutting teeth yourself. To do this, pull
off the cutting edges with an oil stone.
Only sharp cutting teeth provide a
good cutting performance.
Blunt, bent or damaged safety cutter
bars must be replaced.
Have any work that is not described in this
instruction manual performed by our ser-
vice centre. Only use original parts.
Storage
Always store the device:
clean
dry
protected against dust
with blade encasing(10) over the
safety cutter bar (2)
out of the reach of children
Troubleshooting
The following table will assist you in fixing faults:
Problem Possible cause Error correction
No mains power supply Check the socket, mains con-
nection cable, plug and fuse
and have them repaired by a
qualified electrician if neces-
sary.
Safety switch (5) or On/Off
switch (6) defective.
Worn out carbon brushes
Device does not start
Defective motor
contact the service centre.
Power cord (8) damaged
Internal loose contact
Device works with interrup-
tions
Safety switch (5) or On/Off
switch (6) defective.
contact the service centre.
Safety cutter bar (2) blunt
Nicks on safety cutter bar
(2).
Have the safety cutter bar
sharpened or replaced (ser-
vice centre)
Safety cutter bar (2) be-
comes hot.
Too much friction due to lack
of lubrication Lubricate the safety cutter
bar (2)
31


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Parkside PHS 450 A1 - IAN 436117 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Parkside PHS 450 A1 - IAN 436117 in the language / languages: English, German, Dutch, Danish, French, Italian, Polish, Spanish as an attachment in your email.

The manual is 3.62 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info