722849
35
Zoom out
Zoom in
Previous page
1/141
Next page
GB
IE
 31
PAHE 20-Li A1
Sharpening the saw chain
NOTE
You will find detailed information on
sharpening in the sharpening set, e.g. from
Oregon.
Alternatively, you can use an electrical saw
chain sharpening device and follow the
instructions of the manufacturer.
If you have any doubts about implementing the
work, the saw chain
should be replaced.
Initial use
NOTE
Comply with regulations regarding noise
protection and local rules. Using the
appliance on certain days (e.g. on Sundays
and public holidays), during certain times
(midday period, night time) or in certain
locations (e.g. health resorts, clinics, etc.)
may be restricted or prohibited.
Switching on and off
Switching on:
Press the safety lock-out and keep it pressed
and then press the on/off switch .
After the starting process, the safety lock-out
can be released.
Switching off:
Release the ON/OFF switch
.
Checking the automatic oil system
Before starting work, check the window for the oil
level
and the automatic oil system.
Switch the appliance on and hold it over a
lightly coloured floor surface. The appliance
must not touch the ground.
If there is an oil trace, the appliance is operat-
ing correctly.
If there is no oil trace, clean the oil dispenser
or have the appliance repaired by our Customer
Service.
To clean, wipe the residues from the oil dispenser
using a brush or cloth.
Adjusting the telescopic handle
The telescopic handle can be adjusted continu-
ously by means of the quick release .
Activate the quick release
and adjust the
length by pushing or pulling as required.
Close the quick release again, thereby fixing
the desired working length of the telescopic
handle .
If the screw of the quick release has loo-
sened, tighten it again with a hex key.
Adjusting the cutting angle
NOTE
The cutting angle can be adjusted in 3 stages.
Remove the battery pack
from the appliance.
Press the release button
.
Adjust the angle of the motor unit to the required
position.
Let go of the release button
and the motor
unit will click into place.
Insert the battery pack
back into the appliance.
Sawing techniques
WARNING!
Pay attention to falling clippings.
Be aware of the danger of branches flying
back.
NOTE
Place the stop
on the branch. This will help
you work more safely and quietly.
Now you can begin with the sawing.
Sawing off small branches
Saw small branches (Ø 0–8 cm) from the top
down (see figure).
35


Need help? Post your question in this forum.

Forumrules
1

Forum

parkside-pahe-20-li-a1---ian-315261

Reset search

  • I have a PAHE 20-LI A1 rechargeable pruner. the electric motor is faulty. where can I request a replacement? my email is plalazza@libero.it
    Thank you Submitted on 26-3-2024 at 20:48

    Reply Report abuse


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Parkside PAHE 20-Li A1 - IAN 315261 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Parkside PAHE 20-Li A1 - IAN 315261 in the language / languages: English, German, Dutch, French, Polish as an attachment in your email.

The manual is 2,78 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info