745096

Parkside IAN 85052 PSE 2800 B2 Manual

35
Zoom out
Zoom in
Previous page
1/41
Next page
35 GB
Operation / Cleaning, maintenance, storage, transport and ordering of spare parts Cleaning, maintenance, storage, transport and ordering of spare parts
with a clean cloth or blow it down with com-
pressed air at low pressure.
We recommend that you clean the equipment
immediately after you use it.
Clean the equipment regularly with a damp
cloth and some soft soap. Do not use cleaning
agents or solvents; these may be aggressive to
the plastic parts in the equipment. Ensure that
no water can get into the interior of the equip-
ment.
Air filter
In this connection, please also read the service
information.
Clean the air filter at regular intervals, and re-
place it if necessary.
Open both clips (Fig. J/J1) and remove the air
filter cover (Fig. J/J2).
Remove the filter elements (Fig. K/K1)
Do not use abrasive cleaning agents or petrol
to clean the elements.
Clean the elements by tapping them on a flat
surface. In cases of stubborn dirt first clean
with soapy water, then rinse with clear water
and air-dry.
Assemble in reverse order.
Spark plug (Fig. L - M)
Check the spark plug for dirt and grime after
20 hours of operation and if necessary clean it
with a copper wire brush. Thereafter service the
spark plug after every 50 hours of operation.
Pull off the spark plug boot (Fig. L) by twisting.
Remove the spark plug (Fig. M/M1) with the
supplied spark plug wrench
24
.
Assemble in reverse order.
Changing the oil and
checking the oil level
(before using the equipment)
The motor oil is best changed when the motor is at
working temperature.
Only use motor oil (15 W 40).
Place the generator on a slightly inclined sur-
face so that the oil drainage screw
8
is at the
lower end.
Open the oil filler screw
7
.
Open the oil drainage screw and let the hot
engine oil drain out into a drip tray.
After the old oil has drained out, close the oil
drainage screw and place the generator on a
level surface again.
Fill in engine oil up to the top mark on the oil
dip stick (approx. 0.6 liters).
IMPORTANT! Do not screw the dipstick (oil
filler screw) in to check the oil level, simply
insert it up to the thread.
Dispose of the waste oil properly.
Low oil switch-off
The low oil switch-off responds, if not enough en-
gine oil is present. In this case, the engine will not
start or switches off automatically after a short pe-
riod of operation. A restart will only be possible af-
ter topping-up the oil level (see Chapter „Changing
the oil and checking the oil level (before using the
equipment)“).
Preparing the equipment
for long-term storage
Warning: Do not empty the petrol tank in en-
closed areas, near fire or when smoking. Petrol
fumes can cause explosions and fire.
Empty the petrol tank using a petrol suction
pump.
Petrol and oil have to be disposed off accor-
ding to the regulations. Please inform yourself,
where a suitable collection point is near you.
… 35 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Parkside IAN 85052 PSE 2800 B2 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Parkside IAN 85052 PSE 2800 B2 in the language / languages: French as an attachment in your email.

The manual is 2,42 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Parkside IAN 85052 PSE 2800 B2

Parkside IAN 85052 PSE 2800 B2 User Manual - English, German, Dutch - 41 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info