Manual Parkside IAN 315808 PHS 9500 A1 (page 28 of 100) (English, German, Dutch, French, Polish)

749330

Zoom out

Zoom in

1/100

24 GB/IE

9. Before starting the equipment

• Open the packaging and remove the device carefully.

• Remove the packaging material as well as the packaging

and transport bracing (if available).

• Check that the delivery is complete.

• Check the device and accessory parts for transport damage.

When complaints the dealer must be informed immediately.

• If possible, store the packaging until the warranty period has

expired.

ATTENTION

The device and packaging materials are not toys!

Children must not be allowed to play with plastic

bags, ﬁlm and small parts! There is a risk of swal-

lowing and suﬀocation!

• Read the operating instructions to make yourself familiar with

the device prior to using it.

• Only use original parts for accessories as well as for wear-

ing and spare parts. Spare parts are available from your

specialized dealer.

• Specify our part numbers as well as the type and year of

construction of the device in your orders.

The hedge trimmer is supplied without fuel.

This device is operated by a mixture from petrol (unleaded)

and two-stroke engine oil.

Utmost care is required when handling fuel and

oil. Smoking and open ﬁre are not allowed (risk

of explosion).

9.1 Petrol:

• Petrol: Octane number at least 91 ROZ unleaded

• Do not ﬁll in leaded petrol, diesel or other non-approved

fuels.

• Do not use petrol having a smaller octance number than 91

ROZ. This may lead to severe engine damages due to in-

creased engine temperatures.

• If you frequently operate the device at high speeds, you

should use petrol with a higher octane number.

• The use of unleaded petrol is recommended for environment

protection reasons.

9.2 Two-stroke engine oil:

acc. to JASO FC or ISO EGD speciﬁcations

Do not use

• four-stroke oil or two-stroke oil for water-cooled outboard

engines,

• mixtures ready for use from petrol stations.

9.3 Mixing

Ratio of mixture: 40:1

Petrol .................................Two-stroke engine oil 2,5% (40:1)

1 litres ..................................................................0.025 litres

2 litres .................................................................... 0.05 litres

5 litres ..................................................................0.125 litres

10 litres .................................................................0.25 litres

• Measure the oil quantity accurately as a small deviation of

it has a large eﬀect on the ratio of mixture in particular for

small fuel quantities.

• Do not change the ratio of mixture. This will lead to more resi-

dues of combustion, a higher fuel consumption, a decrease

of output or damages to the engine.

Mix petrol and oil in a clean container approved for petrol

and appropriately identiﬁed. Use a fuel container with overﬁll

protection.

1. At ﬁrst ﬁll in half the quantity of petrol to be mixed.

2. Then ﬁll in the total amount of oil.

3. Shake the fuel mixture.

4. Fill in the remaining quantity of petrol, see 6.3.

Fuels have only a limited shelf-life, they are subject to ageing.

Outdated fuels and fuel mixtures may result in starting prob-

lems. Therefore, mix only that quantity of fuel which you can

use within a month. Only store fuels in containers approved

and identiﬁed for this. Keep fuel containers in a dry and safe

area.

Make sure that fuel containers are kept out of the

reach for children.

Caution! Prior to starting the machine learn how to

put it out of action in emergency cases.

9.4 Fuelling the hedge trimmer

• Stop the engine and allow it to cool down.

• Wear protective gloves.

• Avoid eye and skin contact.

• Strictly follow the instructions under “6.3 Safe handling with

fuels”.

1. Only fuel the hedge trimmer in the open or in suﬃciently

ventilated rooms.

2. Clean the area around the ﬁller neck. Contamination in

the tank may result in malfunction.

3. Shake the container once more before pouring the fuel

mixture into the tank.

4. Carefully open the tank cap (11) to allow possible over-

pressure to relax.

5. Carefully ﬁll the fuel mixture up to the lower edge of the

ﬁller neck.

6. Close the tank cap. Check that the tank cap is tight.

7. Clean the tank cap and the area around it.

8. Check the tank and the fuel lines for leaks.

9. Operate the fuel pump (12) if required.

10. Before starting the engine go away at least three metres

from the fuelling place.

9.5 Fitting the impact protector (Fig. 11)

• Fit the supplied impact protector (M) as shown.

10. Attachment and operation

You may not start to operate the machine until you have read

these operating instructions, observed all the instructions given

and completely and properly assembled the machine!

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Parkside IAN 315808 PHS 9500 A1 in the language / languages: English, German, Dutch, French, Polish as an attachment in your email.

The manual is 5,86 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Parkside IAN 315808 PHS 9500 A1 Manual

Product: