Manual Paradyne FrameSaver NP 110 (page 43 of 175) (English)

458602

Zoom out

Zoom in

1/175

4 Operation

4-2 FrameSaver NP 110 User’s Manual - Installation Guide 980-001-0240B

November

2000

Power On

With all the connections completed, the FrameSaver NP 110 is ready to be powered on.

Proceed by holding in the recessed push button switch labeled “NVM RESET” on the

unit’s rear panel while plugging in the power cord and continue to hold the button for

approximately six (6) seconds. This will “clear” the unit’s NVM, resetting all the

configuration parameters to their default values. After the NVM Reset button is

released, the FrameSaver NP 110 will go through the power-on sequence as follows:

a. The UNIT POWER LED will light immediately and stay on.

b. The UNIT READY LED will flash while the unit performs its self-

test (test duration - approximately 60 seconds).

c. The UNIT READY LED will be ON steady after successful comple-

tion of the self-test.

d. The NETW ALARM and UNIT FRM MGMT LEDs should not be

flashing together.

e. All other LED indications should be ignored at this time.

If the LED indications are not as described above, refer to section 5 Diagnostics of this

manual.

NOTE: If the Dial Line has not been connected to the FrameSaver NP 110 prior to

powering the unit on, the unit will issue a Dial Line Failure In-Band Trap to the Trap

Manager after it completes its Modem and Dial Line self test.

Proceed to the next section, “Establish Management Session.”

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Paradyne FrameSaver NP 110 in the language / languages: English as an attachment in your email.

The manual is 1,17 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Paradyne FrameSaver NP 110 Manual

Product: