458602
36
Zoom out
Zoom in
Previous page
1/175
Next page
3 Installation
980-001-0240B FrameSaver NP 110 Users Manual - Installation Guide 3-5
November 2000
FrameSaver NP 110 with ISDN
a. The UNIT POWER LED will light immediately and stay on.
b. The UNIT READY and ISDN READY LEDs will flash while the
unit performs its self-test (test duration - approximately 60 seconds).
c. The UNIT READY and ISDN READY LEDs will be ON steady after
successful completion of the self-test.
d. The NETW ALARM and UNIT FRM MGMT LEDs should not be
flashing together.
e. All other LED indications should be ignored at this time.
If the LED indications are not as described above, refer to section 5 Diagnostics of this
manual.
If operation looks normal, unplug power from the FrameSaver NP 110 before making
any additional connections.
NOTE: The FrameSaver NP 110 does not have a Power ON/OFF switch. To remove
power from the FrameSaver NP 110, disconnect the Power Cord from the AC outlet.
CAUTION
It is recommended that you remove AC power from the
FrameSaver NP 110 before attachin
g
input and output
cables durin
g
the installation process.
Switched AC
Output
Connection
If the FrameSaver NP 110 will be used to control power to another device (usually the
DTE connected to the FrameSaver NP 110), then connect that devices power input to
the
FrameSaver NP 110s Switched AC OUT Socket (IEC 320 female connector), also
shown in Figure 3-2.
36


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Paradyne FrameSaver NP 110 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Paradyne FrameSaver NP 110 in the language / languages: English as an attachment in your email.

The manual is 1,17 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info