734869
11
Zoom out
Zoom in
Previous page
1/16
Next page
11
TQBJ2225
System settings
1 Press and hold [j MENU] for at least 2 seconds.
2 Press [4/:]
§
or [3/9]
§
to select “System”
and then press [ENTER].
3 Press [4/:]
§
or [3/9]
§
to select desired
item or setting and then press [ENTER].
To cancel the setting in the middle, press [j MENU].
If there is an asterisk on the right-hand side of the
menu item, the display is showing the current setting
of the item.
§ Alternatively, you can turn [TUNE/SELECT] to select
menu item/setting.
Heavy, Soft, Clear, Vocal, Flat
” is displayed when “Heavy”, “Soft”, “Clear” or
“Vocal” is set as the equaliser effect.
To turn off the equaliser, select “Flat”. (“ ” will go off.)
When you select the equaliser effect, “Clear-Mode dialog”
will be set to “Off”.
–On, Off
When “On” is selected, the equaliser will be set to “Flat”.
You can change the brightness of the backlight of
display.
Off: The backlight is bright.
Dimmer 1: Dims the backlight.
Dimmer 2: Dims the backlight further.
On: The backlight is always on.
10 sec: The backlight turns off after 10 seconds of
inactivity.
Pressing [DISPLAY] during standby mode will turn on the
backlight for about 10 seconds (except in snooze mode).
(Except for Australia and New Zealand)
You can change the language for the display.
English, Français, Deutsch, Italiano
(Only when “Bluetooth” is selected as the source)
On: The unit automatically turns off when you do
not use it for approximately 20 minutes.
–Off
When connected to a Bluetooth
®
device, the function does
not work.
This setting cannot be selected when radio is the source.
Select “Yes” to reset the unit to factory default setting.
–No, Yes
Troubleshooting
Before requesting service, make the following
checks. If you are uncertain about some of the check
points, or if the solutions indicated in the following
guide does not resolve the issue, then consult your
dealer for instructions.
Sound is distorted or no sound.
Adjust the volume.
If the AC adaptor or fluorescent lights are near the cords,
then keep other appliances and cords away from the
cables.
The batteries are weak. Replace them with new ones.
The current date and time are not displayed
(during standby)
Is the unit running on batteries? If so, connect the AC
adaptor.
Cannot turn on the unit.
When using the unit on battery power, batteries are low.
Connect the AC adaptor to the unit and check that you can
turn the unit on.
When the unit is powered via the AC adaptor, check the
connection of the AC adaptor.
The unit does not work.
One of the unit’s safety devices may have been activated.
1 Press [Í/I] to switch the unit to standby.
If the unit does not turn off, remove the batteries, and
disconnect the AC adaptor from the AC mains socket.
After about 30 seconds, insert the batteries or reconnect
the AC adaptor to the AC mains socket. Then wait for
about 10 seconds.
2 Press [Í/I] to switch it on.
If the unit still cannot be operated, consult the dealer.
Equaliser
Clear-Mode Dialog
Dimmer
Backlight
Language
Auto Power Off
Factory Reset
To return all settings to the factory defaults
Set “Factory Reset” in System menu to “Yes”.
(l above)
The settings are returned to the factory defaults. It is
necessary to set the settings again.
General
RF-D30BT_TQBJ2225_eng.book 11 ページ 2020年5月13日 水曜日 午前11時44分
11


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Panasonic RF-D30BT at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Panasonic RF-D30BT in the language / languages: English as an attachment in your email.

The manual is 1,07 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Panasonic RF-D30BT

Panasonic RF-D30BT User Manual - German, Dutch, Danish, French, Italian, Polish, Swedish, Norwegian - 112 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info