548352
92
Zoom out
Zoom in
Previous page
1/108
Next page
Maintenance/Replacement
92 - ENGLISH
Maintenance
Replacing the lamp unit
Attention
z
When the projector is mounted on the ceiling, do not put your face near the lamp unit.
z
Securely attach the lamp unit and lamp unit cover.
z
If the lamp unit is not installed properly, remove it and then install it again. Pushing it in forcibly may break the
connector.
1) Follow the procedures described in
Powering off the projector (
page 35)
to set the <MAIN POWER> switch to
<
OFF>, disconnect the power plug
from the power outlet, and wait at least
one hour, and then check if the lamp
unit has cooled down.
2) Remove the lamp unit cover.
(a) Use a Phillips screwdriver to loosen the
lamp unit cover xing screw (one screw)
until it turns freely, and then open the lamp
unit cover in the direction of the arrow.
(b) Hold the lamp unit rmly, slide it towards the
control buttons, then pull it out.
(a)
(b)
Lamp unit cover
Lamp unit cover
fixing screw
3) Use a Phillips screw driver to remove
the lamp unit xing screws (three
screws each), and then holding the
handles, pull out the lamp unit from
the projector.
Handles
Lamp unit 1
Lamp unit 2
Lamp unit fixing screws
4) Carefully push the new lamp unit into
the projector.
5) Use a Phillips screw driver to tighten
the lamp unit xing screws (three
screws each).
6) Attach the lamp unit cover.
(a) Attach the lamp unit cover by aligning the (i)
and (ii) symbols (
and ).
(b) After sliding the lamp unit cover in the
direction of the arrow and inserting it
forward, securely tighten the lamp unit cover
xing screw.
z
Make sure that the lamp unit cover connector is
rmly inserted into the fan power connector.
(a)
(b)
(i)
(ii)
Fan power connector
Lamp unit cover
fixing screw
Lamp unit cover
Note
z
When you replace the new lamp unit, the projector
resets the total usage time of the lamp unit
automatically.
92


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Panasonic PT-DW730UK at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Panasonic PT-DW730UK in the language / languages: English as an attachment in your email.

The manual is 12,32 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info