598890
45
Zoom out
Zoom in
Previous page
1/129
Next page
Projecting
ENGLISH -
45
Basic Operation
If the lens is heavy or the projector is installed so that it is tilted, the lens may be tilted, resulting in the focus
becoming unbalanced.
In such a case, refer to the gure 3 and table below, and follow the procedure below to perform adjustment.
Adjustment procedure
Q
Display the internal test pattern grid, and defocus the image.
Adjust the lens focus till one or more sides of the grid comes into focus. Note the appropriate screws
for the out-of-focus sides of the grid as described below.
Loosen the locking screws for each of the adjustment screws , and as needed, following the
indications in the example. The screws to be adjusted correspond to the out-of-focus sides of the
image.
Attention
Make adjustments in up to two places, and fully turn the screw clockwise in at least one place.
z
Turn the adjustment screws (corresponding to the locking screws loosened in step 3)
counterclockwise slightly till the out-of-focus image sides are in focus. (Turning the screws
counterclockwise moves the lens bracket and tilts the lens toward the screen.)
Readjust the lens shift position with the remote if needed.
Refocus the image as in steps 1 and 2 above. Fine adjust the focus evenness as needed, as described
in step 4.
When adjustment is complete, tighten the locking screws.
Adjust the Focus.
Tool to be used : Allen hex socket driver or Allen wrench (2.5 mm diagonal hexagon)
An Allen wrench is supplied with the ET-D75LE6 and ET-D75LE8 optional lens.
Figure 3 : Relation between the adjustment place and adjustment screw
When optimal focus point
is at the back of screen
for V up
When optimal focus point
is at the back of screen
for V bottom
When optimal focus point
is at the back of screen
for H left
When optimal focus point
is at the back of screen
for H right
Turn counterclockwise ——— ——— ———
——— Turn counterclockwise Turn counterclockwise ———
——— Turn counterclockwise ——— Turn counterclockwise
Adjustment place :
The place where the just-in-focus
point is at the back.
Projector
Screen
45


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Panasonic PT-DS8500 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Panasonic PT-DS8500 in the language / languages: English as an attachment in your email.

The manual is 12,55 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info