614030
38
Zoom out
Zoom in
Previous page
1/52
Next page
Others
-38-
ª Inserting/Removing the Cassette
In the case of using a previously recorded
Cassette, you can use the Camera Search
Function to find the position where you want to
continue recording.
If a new Cassette is inserted, rewind to the
beginning of the tape before starting recording.
When inserting the cassette, make sure it faces
in the right direction and then push it in until it
stops.
When the Cassette Holder is in action, do not
touch anything except the [PUSH CLOSE]
Button.
When closing the Cassette Compartment
Cover, do not get anything caught in the cover,
such as a cable of an optional stereo
microphone.
ª Alarm Sounds
When [BEEP SOUND] on the
[OTHER FUNCTIONS1] Sub-Menu on the
[CAMERA FUNCTIONS] Main-Menu is set to
[ON], confirmation/alarm beeps are issued as
follows.
1 Beep
When you start recording
When you switch the [OFF/ON/MODE] Switch
from [OFF] to [ON]
2 Beeps
When you pause recording
2 Beeps for 4 times
If you perform a wrong operation before or
during recording
ª Recording Check
For Recording Check, the recording speed
mode (SP/LP) must be the same as the mode
used for the recording. If different, playback
images will be distorted.
ª Camera Search
In Camera Search Mode, images may contain
mosaic-pattern noise. This is a phenomenon
that is characteristic of digital video and not a
malfunction.
If the recording speed modes (SP/LP) of
previous recording and new recording are
different, playback images may be distorted.
ª Quick Start
During the Quick Start Standby Mode, a minute
amount of electricity is consumed.
When the Movie Camera is left in the Recording
Pause Mode for 6 minutes, it will be turned into
the Quick Start Standby Mode. To turn the
Movie Camera on again, set the
[OFF/ON/MODE] Switch to [OFF] and then set it
to [ON] again. (The Quick Start Mode will be
restored.)
This Function is not activated when a tape is not
inserted even if the Quick Start Recording Lamp
lights:
In the following cases, Quick Start is temporarily
cancelled when the Quick Start Mode is set. Set
the Camera Mode again, and the Quick Start
Mode will be restored.
Set to the VCR Mode
The Battery is replaced
If the [QUICK START] Button is pressed and
held for approximately 2 seconds during the
Quick Start Standby Mode, the Lamp will go off
and the Movie Camera will completely be turned
off.
If the Movie Camera is not operated for
approximately 30 minutes when the Quick Start
Recording Lamp lights, the Lamp will go off and
the Movie Camera will completely be turned off.
In the Automatic White Balance Mode, the
colour may be recorded unnaturally at the
beginning of the recording.
The zoom magnification differs from when it is
in the Quick Start Standby Mode and when the
recording starts.
ª Photoshot
Photoshot Recording results in slightly inferior
image quality.
ª Progressive Photoshot Function
The still pictures are recorded at a slightly
rewound point from where you press the
[PHOTO SHOT] Button.
When you change to the Still Picture Mode, you
will hear a click. This is the sound of the iris
closing and not an indication of malfunction.
If you record still pictures in Progressive
Photoshot Mode when your Movie Camera is
set to Programme AE (
-22-), the brightness of
the images may change.
Using the Night View Functions cancels the
Progressive Photoshot Function.
About [PROGRESSIVE] Setup
When the [æ] Indication is displayed, you can
use the Progressive Photoshot Function.
When [PROGRESSIVE] is [ON]:
You can use the Progressive Photoshot Function
at any time. In this case, however, the following
functions are disabled.
Digital Effect Modes in [EFFECT1]
-25-
Digital Zoom [D.ZOOM] -20-
1/750 s or faster shutter speed -24-
When [PROGRESSIVE] is set to [AUTO]
You cannot use the Progressive Photoshot
Function in the following cases.
When the zoom magnification is approximately
10k or higher
When the shutter speed is 1/750 s or faster
30B-ENG.book 38 ページ 2003年1月23日 木曜日 午後8時46分
38


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Panasonic NV-GS30 B at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Panasonic NV-GS30 B in the language / languages: English as an attachment in your email.

The manual is 4,21 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info