614030
37
Zoom out
Zoom in
Previous page
1/52
Next page
Others
-37-
ª To Change the Display Mode
By changing [DISPLAY] on the
[DISPLAY SETUP] Sub-Menu, you can change
the Display Mode to All Function Display [ALL],
Partial Display [PARTIAL] and Minimum Display
[OFF]. (
-14-)
Owner ID
You can register your name and address in your
Movie Camera to identify the owner.
1 Set [CAMERA FUNCTIONS] >>
[OTHER FUNCTIONS1] >> [OWNER ID SET]
>> [YES].
The [OWNER ID] Menu appears.
2 Turn the [PUSH] Dial (32) to select
[PIN NUMBER] and press the [PUSH] Dial
(32) to input desired numbers.
3 Turn the [PUSH] Dial (32) to select numbers
and press the [PUSH] Dial
(32) to enter
them.
Be sure to input 4 digits. Otherwise the Pin
Number will not be registered.
4 Press the [] Button.
5 Repeat Steps 2–4 to input desired
characters for [NAME] and [POSTCODE].
You can input up to 12 characters in [NAME],
and up to 11 characters in [POSTCODE].
6 Press the [] Button to finish the setup.
To Verify Owner ID
Keep pressing the [;] Button for approximately
5 seconds.
To Correct the Contents
If Owner ID has already been set, carrying out
Step 1 will display [INPUT PIN NUMBER] on the
screen. Input the Pin Number you have already
selected. If the number is not correct, the screen
will not change. If the number is correct, the
contents of the setup will be displayed. (By
repeating Steps 2 to 4, you can change the
contents.)
Initializing the Modes
You can change the Menu settings back to the
shipping condition.
1 Set [CAMERA FUNCTIONS] >>
[OTHER FUNCTIONS2] >> [INITIAL SET] >>
[YES].
The initializing takes for a while.
After the initializing is completed, the
[COMPLETED] Indication appears with
beeps.
Initializing will not erase the Owner ID setting
and the clock setting (
-15-) that has been
adjusted.
Warning/Alarm Indications
If any one of the following indications lights up or
flashes, please check the condition of the Movie
Camera.
3: Condensation has occurred.
-43-
Y: The accidental erasure prevention slider on
the inserted Cassette is open (that is, set to
[SAVE]).
You are about to do audio dubbing on the
unrecorded (blank) portion of the tape.
No Cassette is inserted.
-12-
6: The Battery is low. Recharge it. -9-
0: The built-in battery is low. -16-
:: The video heads are dirty. -43-
2END:
The tape came to end during recording.
REMOTE:
Wrong Remote Controller Mode has been
selected.
-9-
UNPLAYABLE TAPE
(OTHER FORMAT):
You are attempting to play back a tape
section that has been recorded with a
different TV system.
UNABLE TO A. DUB
(LP RECORDED):
Because the original recording was done in
LP Mode, audio dubbing cannot be
performed.
INCOMPATIBLE TAPE:
This Cassette is incompatible.
PLEASE RE-OPERATE
AFTER PUSHING
RESET BUTTON:
Mechanism Irregular is detected. Press the
[RESET] Button (
-7-). This may solve the
problem.
TO SERVICE:
It is a malfunction.
COPY INHIBITED:
Because the medium is protected by a copy
guard, images cannot be recorded
correctly.
Notes and Hints
ª Concerning the Power Supply
When the Movie Camera is used for a long time,
the Camera body becomes warm, but this is not
a malfunction.
If the [CHARGE] Lamp does not light up
although the Battery is attached to the AC
Adaptor, detach the Battery and reattach it.
ENGText.fm 37 ページ 2003年2月24日 月曜日 午後9時58分
37


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Panasonic NV-GS30 B at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Panasonic NV-GS30 B in the language / languages: English as an attachment in your email.

The manual is 4,21 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info