113
Chapter 6Useful Information
Problem
The information of the Caller List is
erased.
does not function.
The paged handset does not answer.
While conversation, two tones sound.
The unit misdials when connected to a
PBX.
You cannot register the handset in the
base unit.
All indicators light and never goes out.
The battery strength is not displayed
correctly.
“ ” flashes or the unit beeps every
15 seconds.
You charged the batteries fully, but
“ ” flashes.
Cause and Remedy
•
When disconnecting the AC adaptor from the base
unit, all entries of the Caller List will be erased.
•
The handset is too far from the base unit.
•
The handset is engaged in an outside call or is
viewing the Caller List or phonebook.
•
The handset is not in the same radio area.
•
The handset is engaged in an outside call.
•
The handset has been canceled or has not been
registered. Register the handset in the base unit
(p. 19).
•
A call is being received. Press to answer.
•
Please confirm the Automatic Access Code Insertion
feature if you set.
•
The base unit has registered a maximum of 8
handsets or the handset has registered a maximum
of 4 base units.
•
A wrong base unit PIN was entered. Enter the correct
PIN .
•
There is interference from other electrical units.
Locate the handset and base unit away from them.
•
You must finish registration within 1 minute after the
ringer tone sounds, or programming will be canceled
(p. 19).
•
Please consult your nearest Panasonic Service
Center.
•
Make sure the Panasonic P-6P or BYD
PQHB120AA12 is installed (p. 109).
•
Charge the batteries fully (p. 12).
•
Clean the charge contacts and charge again (p. 12).
•
Install new batteries (p. 109, 110).
