GB
35
Saving and recalling data
34
1. Press the Memory/Recall button.
• The average of all recorded readings will be
displayed.
• The mark will be displayed.
• If, for example, 42 sets of readings have been saved
in the memory then the average of those 42 sets of
readings will be displayed. If only one set of readings
has been saved then the mark will not be
displayed.
2. Press the Memory/Recall button again to display
the most recent reading.
• Each time you press the Memory/Recall button
another set of readings will be displayed, starting with
the next most recent readings.
• Nothing will be displayed when no readings have
been saved.
3. Press the On/Off and Start button to turn off the
device.
The device will turn off automatically after 30 seconds
if you forget to turn it off.
Recalling Stored Data
Readings can be recalled after being saved without having to first turn the
device on.
Deleting all data stored in the memory
(1) Use the Memory/Recall button to access saved data.
(2) Press the Memory/Recall button again and hold it down for more
than three seconds to delete all data.
* It is not possible to delete individual readings.
(3) When all data has been deleted the mark and will be
displayed.
1. After measurement has been completed the
mark will flash.
Press the Memory/Recall button.
2. Saving complete.
• Up to 42 sets of readings can be stored in memory
and each is assigned a number. When the limit is
reached, any new readings are recorded over existing
readings starting with the oldest ones. The data
numbers will also be changed.
• It is not possible to save readings when measurement
has not been carried out successfully (i.e. when an “E”
is displayed). As nothing will be recorded the data
number will not be changed.
* Readings can, however, be saved when the “E” mark
is displayed for the pulse rate.
Saving readings
• All data is retained even when the batteries go flat or are changed.
(After approx.
one second.)
(After approx.
one second.)
EW3004EU_023.qxd 05.2.2 2:20 PM ページ 34
