456889
62
Zoom out
Zoom in
Previous page
1/80
Next page
62
RQTV0134
Troubleshooting guide
Operation Page
Cannot operate the TV. Change manufacturer code. Some TVs cannot be operated even if you change the code.
Press [TV/VIDEO] to change the input mode to “TV”.
19
26
Cannot operate the DVD. Press [DRIVE SELECT] to select DVD drive when operating DVD. 11
Cannot operate the VHS. Press [DRIVE SELECT] to select VHS drive when operating VHS. 11
The remote control doesn’t
work.
The remote control code is wrong. Change to the correct code.
The batteries are depleted. Replace them with new ones.
Point the remote control at the remote control sensor on the main unit.
Remove obstacles between the remote control and main unit.
Colored glass may abstruct the signal reception/transmission.
Don’t place the signal sensor in direct sunlight or in areas that may be subject to sunlight exposure.
It may be necessary to set the code on the remote control again after changing the batteries.
It may be necessary to set the manufacturer code again after changing the batteries.
19
9
9
9
9
The unit is on but cannot be
operated.
Some operations are prohibited by the disc.
The unit is warm (“U59” appears on the unit’s display). Wait until “U59” disappears.
One of the unit’s safety devices may have been activated.
Reset the unit as follows:
(1) Press [Í/I, POWER] on the main unit to switch to standby.
If the unit doesn’t switch to standby, press and hold [Í/I, POWER] on the main unit for about 10
seconds. The unit is forcibly switched to standby.
Alternatively, disconnect the AC power supply cord, wait for about 1 minute, then reconnect it.
(2) Press [Í/I, POWER] on the main unit to turn the unit on.
Cannot eject a disc. The unit is recording
The unit may have a problem. While the unit is off, hold down [] and [CH, W] on the main unit
simultaneously for about 5 seconds. Remove the disc and consult the dealer.
Startup is slow Make sure that “Quick Start” is set to “On”.
Even if “Quick Start” is set to “On”, startup is slow if the clock is not set, there was a power failure or
the AC plug has just been connected.
A few dozen seconds after turning on the unit, you can play a disc or start recording to discs other
than DVD-RAM.
56
Takes time to read DVD-RAM It may take time to read a disc if it is being used for the first time in this unit or it has not been used
for a long time.
M6VP&PC.book 62 ページ 2006年2月6日 月曜日 午後3時20
62


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Panasonic DMR-ES35 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Panasonic DMR-ES35 in the language / languages: English as an attachment in your email.

The manual is 4,66 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Panasonic DMR-ES35

Panasonic DMR-ES35 User Manual - German - 60 pages

Panasonic DMR-ES35 User Manual - Dutch - 60 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info