779807
21
Zoom out
Zoom in
Previous page
1/32
Next page
6.3. Spark plug.
The spark plug MUST be fully tightened otherwise the engine will overheat causing and
damage to cylinder head may occur. Always complete the following steps after the engine
has been turned off and allowed to cool down. DO NOT allow any debris to enter the
cylinder.
6.3.1. To remove the spark plug, you must first undo the HT lead then using the supplied
box spanner undo the spark plug (anti-clockwise direction).
Check the condition of the spark plug for signs of wear to the electrodes and carbon
deposits. To removes carbon deposit you can use a soft brass brush. Check the gap of the
plug and make sure it is correctly gapped to a gap of 0.6mm to 0.7mm. You MUST also check
the condition of the washer, if it is damaged it MUST be replaced.
Spark plug tightening for new plug - once washer is sealed turn one extra 1/2 turn, for
existing spark plug with old washer turn an extra 1/8 to 1/4 turn.
Page 21
First edition - April 2017
21


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for P1PE P73200T at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of P1PE P73200T in the language / languages: English as an attachment in your email.

The manual is 9.45 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info