Page 10 of 18
6. Cable work inside the vehicle
a) Guide the cable coming through the roof to the receiver. Any
remaining cable must not be cut but should be wound neatly and
stored close to the receiver.
c) Connect the SCART or the coax cable to the receiver and
interconnect it to your display. Take care to fix the cables to
prevent the connectors from falling out at a later time when the
vehicle is travelling.
d) Connect the 3-pin power connector to the receiver. Make sure
that the receiver's main switch is in OFF or “0” position. You
have to extend the 3 short pieces of wire to connect it to the
matching terminals inside the vehicle. Refer to page 9 for the
power interconnection.
e) Connect the 8-pin RJ45 connector coming from the sat-
mouse. Place the mouse onto an acceptable position and guide
the cable properly to the mouse position. Any remainder of cable
should be wound neatly and stored close to the receiver.
This cable is about 1.5m long. If this is not sufficient for the
intended sat-mouse position you can obtain any 8-pin “ISDN
type” telephone extension cable at a maximum of 5 meters to
extend this cable.
