606568
6
Zoom out
Zoom in
Previous page
1/42
Next page
6. We recommend that the wiring loom is positioned away from existing wiring looms on the
motorcycle to avoid any possible electrical interference issues.
7. When the wiring is in position on the motorcycle, we strongly recommend that all connectors are
protected with either electrical insulation tape, waterproof sealing tape or heat shrink tubing
(be careful not to damage the cable when fi tting heat shrink).
8. Both the negative and the positive battery connections are fi tted with a ring terminal. This will allow
them to be bolted to the battery terminals. It is both preferable and the easiest option to connect the
positive (+ Red wire) straight to the positive (+) battery terminal so that the switch receives suffi cient
voltage from the vehicles charging system.
9. The negative or earth (Black wire) should be connected to the negative (-) battery terminal.
10. The control box (see drawing below) can be positioned under the motorcycle seat or near to the
battery. But we recommend that it is kept at least 1” or 25mm away from the battery at all times.
11. If the switch must be connected to a switched ignition supply feed, please ensure that the wiring
harness is connected to main ignition cabling which can take the extra load of up to 4 amps.
Problems are commonly found to be caused when connections are made to horn or any lighting
circuits.
Typical problems experienced could be:
- The switch may not come on
- Fuses failing in the fuse box
- Overheating of wires on the bike
- Indicators or lighting malfunctioning
If unsure, please contact your local dealer for advice before fi tting these Hotgrips.
Control box
Heat
controller
5 amp
fuse
+
Battery
connections
Refer to the wiring diagram below.
5 Oxford Hotgrips instructions v.7 switch - 10/12/08
6


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Oxford OF696 HotGrips at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Oxford OF696 HotGrips in the language / languages: English, German, French, Italian, Spanish as an attachment in your email.

The manual is 0,73 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Oxford OF696 HotGrips

Oxford OF696 HotGrips Usermanual and installation guide - Dutch - 8 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info