682682
26
Zoom out
Zoom in
Previous page
1/38
Next page
25
7.2 Seat Angle Adjustment
The A200 offers seat angle settings in 3 different positions (0°, 3° and 6°). For setting the position, 2 quick release
levers are used which are located at the front below the seat. To change the seat angle, loosen the two quick
release levers. Adjust the desired seat angle by simultaneously lifting the seat slightly and pushing the brackets to
the rear. Ensure that the brackets completely engage in the new position and tighten the quick release levers.
Note:
Ensure the quick release levers are snugly tightened after all seat angle adjustments!
Note:
During seat angle adjustments the user must not sit in the wheelchair.
7.3 Armrest
Remove the armrests by loosening the thumb screws at the lower end of the armrest and lifting the armrest upwards
(Fig. 10).
Both armrests can be removed, however, only the side without the control panel can be removed directly. Before
removing the armrest on the side with control panel, the joystick control panel must be removed (Fig. 11).
Figure 10 Figure 11
The armrest height can be changed by loosening the set screw at the upper end of the armrest holder. Ensure the
set screw is retightened after making any adjustments.
7.4 Control Panel
7.4.1 Removing the Joystick Control Panel
The joystick control panel can be removed by pulling it to the front.
7.4.2 Adaptation to the Arm Length
After loosening the attachment screws on the underside of the armrest, the control panel mounting can be adjusted
to the front or to the rear and thus adapted to the desired arm length (Fig. 12). Ensure all attachment screws are fully
tightly after adjustment.
Figure 12
26


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Otto Bock A 200 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Otto Bock A 200 in the language / languages: English, German as an attachment in your email.

The manual is 2,61 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info