E36Motor direction errorCritical switch safetyline / Check connection Level Motor
E37Gate supply voltage missing, SLA and/or SLB not active (Tilt sensor?)Critical switch safetyline / Replace Level Board Calibrate chair and liftsensor
E38 *
High impuls current (overcurrent){In softw. before version L27,this was low supply volt error}
Blocking of motor / Check wiring encoderAdjust seat horizontal. (by handwind)
press both buttons on SCB
E40PCB error Sensor control BoardReplace Sensor Control Board => calibate sensors after replacementdisplay will show blinking 'h'
E41Liftsensor Fault 1 (ADC)Replace Sensor Control Board => calibate sensors after replacementHold buttons until blinking 'h' stops.
E42Liftsensor Fault 2 (V)Replace Sensor Control Board => calibate sensors after replacementWhen 'h' is continue visible release buttons
E43
Liftsensor Fault 3 (Ω)
Replace Sensor Control Board => calibate sensors after replacementSensors are calibrated.
E44Checksum error (Configs)Replace Sensor Control Board => calibate sensors after replacement
E45System never has been calibrated. (factory default)Calibrate sensors
E50Chairsensor outside range -3,5 or +3,5 degreesFirst check and set angle of Chairframe, do restart, and read 'new' error / or sensor not correctly calibrated
Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.
Product:
Forumrules
To achieve meaningful questions, we apply the following rules:
First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.
Register
Register getting emails for Otolift One at:
new questions and answers
new manuals
You will receive an email to register for one or both of the options.
Get your user manual by e-mail
Enter your email address to receive the manual of Otolift One in the language / languages: English as an attachment in your email.
The manual is 4,36 mb in size.
You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.
The manual is sent by email. Check your email
If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.
The email address you have provided is not correct.
Please check the email address and correct it.
Your question is posted on this page
Would you like to receive an email when new answers and questions are posted? Please enter your email address.
