587045
7
Zoom out
Zoom in
Previous page
1/31
Next page
7
ENG
Charging the handset batteries
You must charge the handset batteries for 15 hours the first time you use them.
The battery icon on the handset display becomes progressively empty as the batteries become low.
When the batteries are fully charged, the icon looks full and dark, as shown here
. When the icon
appears empty as shown here
or if you hear the warning beep during a call, please:
End the call as soon as possible.
Don’t use the speakerphone mode since this consumes more energy than the normal talk mode.
Put the handset back on the base unit for charging until the battery icon returns to high level.
To charge the handset, put it back in the base cradle with the keypad facing outwards. The blue
CHARGE light on the base unit steadily lights to indicate that the handset is charging. When the battery
indicator appears full, and the charge light goes off, the batteries are fully charged.
Replacing the handset batteries
Rechargeable batteries may need to be replaced from time to time. If you find that you can no longer
recharge the batteries, replace them with two new batteries of the same size (AAA) and type
(rechargeable Ni-MH) following the instructions on page 6.
Attaching the belt clip
To attach the belt clip to the back of the handset:
1. Slide the belt clip over the back of the handset until the ventilation holes are aligned.
2. Gently push the belt clip until it clicks into place.
Installing the remote sensor batteries
Your ThermoDECT telephone is shipped with two
regular batteries (AAA size). To install the batteries:
1. Open the battery compartment located at the
back of the remote sensor.
2. Insert the batteries as shown in the diagram to
the right, matching positive (+) polarity to
positive, and negative (-) polarity to negative.
Note: Reversing the polarity may damage the
remote sensor.
3. Replace the battery compartment by sliding it in the direction shown by the arrow in the diagram to
the right. The lid clicks into place when it is secure.
Replacing the remote sensor batteries
The batteries may need to be replaced from time to time. Replace them with two new batteries of the
same size (AAA) and type following the instructions on above.
USING YOUR TELEPHONE
Before you start
When you first set up your unit, you may hear an out of range beeping tone and see the words Base 1
flashing on the handset display area. This is normal, and means that the handset needs to synchronize
with the base unit before you can use it. Hold the handset near the base unit for a few seconds until
the handset display stops flashing.
7


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Oregon Scientific TD339 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Oregon Scientific TD339 in the language / languages: English as an attachment in your email.

The manual is 1,08 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Oregon Scientific TD339

Oregon Scientific TD339 Quick start guide - English - 2 pages

Oregon Scientific TD339 User Manual - French - 34 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info