631680
15
Zoom out
Zoom in
Previous page
1/128
Next page
V 2.2.0t1b
Oplink Communications, Inc. 14
Set up and wall-mount the motion sensor
Step 1: Insert Battery
a. Lift top tab on cover to release and remove cover.
b. Insert the battery noting the polarity (CR123A), and replace the cover onto the sensor.
Step 2: Install Motion Sensor
a. Place the motion sensor appropriately to ensure maximum coverage of a monitored
area. The motion sensor monitors any movement up to 35 feet away and should not
be placed higher than 7 feet from the floor.
b. For maximum coverage, it is recommended that the sensor be placed in the corner
of the room to be monitored.
c. Use the larger piece or the two thin pieces of double-sided tape to mount the
motion sensor at the desired location on the wall or corner of the room.
d. Make sure the motion sensor is placed at an angle with the least amount of
obstruction for best coverage.
e. The sensor is most effective in areas such as hallways and entry points where
intruders will have to pass through.
3-Minute Cool Down Period
A 3-minute cool down period is programmed into the Motion Sensor. This helps reduce false alarms and
prolongs battery life. After the most recent event has been triggered, the next motion detected by the sensor
can happen only after the 3-minute countdown has elapsed. When/If motion is detected within the cool
down period, the 3-minute countdown will restart.
Initial Test Mode and Power-Save Mode
The Motion Sensor has 2 modes: Initial Test Mode and a Power-Save Mode.
The Initial Test Mode occurs during the first hour after a battery is put into the device, as is the
case during the initial installation of the system. Within this hour, whenever the Motion Sensor
15


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Oplink TripleShield at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Oplink TripleShield in the language / languages: English, German, Dutch, French, Spanish as an attachment in your email.

The manual is 1,26 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Oplink TripleShield

Oplink TripleShield Installation Guide - English - 17 pages

Oplink TripleShield User Manual - English - 27 pages

Oplink TripleShield Installation Guide - English - 1 pages

Oplink TripleShield Installation Guide - German, Dutch - 17 pages

Oplink TripleShield User Manual - Dutch - 26 pages

Oplink TripleShield Installation Guide - French, Italian, Spanish - 17 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info