645333
85
Zoom out
Zoom in
Previous page
1/96
Next page
85
Zone 2
—Continued
To control the AV receiver with the remote controller
while you’re in the Zone 2 room, you’ll need a commer-
cially available multiroom remote control kit.
Multiroom kits are made by Niles and Xantech.
These kits can also be used when there isn’t a clear line
of sight to the AV receiver’s remote sensor, such as when
it’s installed inside a cabinet.
Using a Multiroom Kit with Zone 2
In this setup, the IR receiver in Zone 2 picks up the infra-
red signals from the remote controller and feeds them
through to the AV receiver in the main room via the con-
necting block.
The miniplug cable from the connecting block should be
connected to the AV receiver’s IR IN jack, as shown
below.
Using a Multiroom Kit with a Cabinet
In this setup, the IR receiver picks up the infrared signals
from the remote controller and feeds them to the AV
receiver located in the cabinet via the connecting block.
Using a Multiroom Kit with Other
Components (TX-SR803/803E Only)
In this setup, an IR emitter is connected to the
TX-SR803/803E’s IR OUT jack and placed in front of
the other component’s remote control sensor. Infrared
signals received at the AV receiver’s IR IN jack are fed
through to the other component via the IR emitter. Sig-
nals picked up by the TX-SR803/803E’s remote control
sensor are not output.
The IR emitter should be connected to the
TX-SR803/803E’s IR OUT jack, as shown below.
Using the Remote Controller in
Zone 2 and Multiroom Control Kits
Connecting
block
Remote controller
IR Receiver
Main room Zone 2
Signal flow
TX-SR803/803E
TX-SR703/703E/8370
From the connecting block
Miniplug cable
IR IN
Connecting
block
Remote controller
IR Receiver
Inside
cabinet
Signal flow
TX-SR803/803E
IR IN
IR OUT
Connecting
block
IR Receiver
Remote controller
Signal flow
IR Emitter
Other component
TX-SR803/803E
Remote control
sensor
Other component
Emitter
IR Emitter
Signal flow
Miniplug
Miniplug cable
TX-SR803_En.book Page 85 Friday, August 26, 2005 9:26 AM
85


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Onkyo TX-SR703 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Onkyo TX-SR703 in the language / languages: English as an attachment in your email.

The manual is 5,08 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info