645312
56
Zoom out
Zoom in
Previous page
1/60
Next page
56
Troubleshooting
Symptom Possible cause Remedy
Power
The TX-SR502/TX-SR502E
shuts down immediately
after being turned on?
The amp protection system has been acti-
vated.
Contact your Onkyo dealer.
Audio
There’s no sound coming
from the speakers?
The TX-SR502/TX-SR502E is muted and
the MUTING indicator is on.
Unmute the TX-SR502/TX-SR502E
(page 39).
The TX-SR502/TX-SR502E is not con-
nected properly.
Make sure that all audio connecting plugs are
pushed in all the way. And make sure that the
inputs and outputs of all components are con-
nected properly (page 20).
If your turntable doesn’t have a built-in
phono preamp, you must connect one
between your turntable and the TX-SR502/
TX-SR502E.
If your turntable uses an MC cartridge, you
must use a compatible phono preamp.
The speaker cables are not connected
properly.
Make sure that the polarity of the speaker
cables is correct and that the bare wires are in
contact with metal part of each speaker ter-
minal (page 17).
The wrong input source is selected. Select the correct input source (page 34).
A pair of headphones are connected. Disconnect the headphones (page 39).
The input signal format is set to PCM or
DTS.
Set the input signal format to Auto (page 47).
The volume is set at minimum. Turn up the volume (page 34).
The speakers are configured incorrectly.
Specify which speakers are connected
(page 32), the speaker distances (page 48)
and adjust the individual speaker levels
(page 49).
The source component is not outputting dig-
ital audio.
Check the digital audio output setting on the
connected device. On some games consoles,
such as those that support DVD, the default
setting is off.
A compatible digital audio format is not
selected on the source component.
With some DVD-Video discs, you need to
select an audio output format from a menu.
The center speaker is not
working or is very quiet?
The Stereo, Direct, Pure Audio, or Orchestra
listening mode is selected.
The center speaker is not used with these
modes (page 42).
The level of the center speaker is set at
minimum.
Check the volume of the center speaker
(page 49).
The Center setting is set to None in the
Speaker Configuration.
Check the Center setting in the Speaker Con-
figuration (page 32).
Only the center speaker is
working?
You’re listening to a mono sound source
(e.g., TV or AM broadcast) and the PL II/PL
IIx Movie or PL II/PL IIx Music listening
mode is selected, so the sound is concen-
trated in the center speaker.
Select another listening mode (page 42).
The surround speakers are
not working?
Selected listening mode doesn’t use surround
speakers.
When the Stereo, Direct, or Pure Audio lis-
tening mode is selected, the surround speak-
ers produce no sound (page 42).
Surround speaker output depends on the
source material, and some material may not
use the surround speakers much.
The level of the surround speaker is set at
minimum.
Check the volume of the surround speaker
(page 49).
The Surround setting is set to None in the
Speaker Configuration.
Check the Surround setting in the Speaker
Configuration (page 32).
TX-SR502_En.book Page 56 Tuesday, February 17, 2004 12:14 PM
56


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Onkyo TX-SR502 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Onkyo TX-SR502 in the language / languages: English as an attachment in your email.

The manual is 5,36 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Onkyo TX-SR502

Onkyo TX-SR502 User Manual - German, Dutch - 236 pages

Onkyo TX-SR502 User Manual - French - 120 pages

Onkyo TX-SR502 User Manual - Italian, Swedish - 236 pages

Onkyo TX-SR502 User Manual - Spanish - 120 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info