553769
24
Zoom out
Zoom in
Previous page
1/97
Next page
24
Connecting to Audio/Video Equipment—Continued
Using an RCA audio connection cable, connect the
output jacks of the turntable to the PHONO audio jacks
of the TX-NR801/TX-NR801E. Make sure that you
properly connect the left channel to the L jack and the
right channel to the R jack.
Note:
The TX-NR801/TX-NR801E is designed for use with
moving magnet cartridges. For proper operation, con-
nect a ground (or earth) wire to the GND terminal. For
some turntables, however, connecting the ground wire
may cause increased noise, and in such a case, a ground
wire is not necessary and should not be connected.
Using RCA audio connection cables, connect the output
jacks (PLAY) of the device to the TAPE AUDIO IN
jacks of the TX-NR801/TX-NR801E and connect the
input jacks (REC) of the device to the TAPE AUDIO
OUT jacks of the TX-NR801/TX-NR801E. Make sure
that you properly connect the left channels to the L
jacks and the right channels to the R jacks.
If the device has a digital output, connect it to either the
DIGITAL IN COAX jack or DIGITAL IN OPT jack of
the TX-NR801/TX-NR801E, depending on the type of
connector on the device.
On the initial settings of the TX-NR801/TX-NR801E,
the TAPE input source is set for digital input at the
OPT 2 jack.
If the digital connection is made to a different jack, this
must be changed at Setup Menu Input Setup
Digital Setup (See page 36).
If the device has a digital input, connect it to the
DIGITAL OUT OPT jack of the TX-NR801/
TX-NR801E for digital recording of the REC OUT
signal from the TX-NR801/TX-NR801E.
However, if the same device also has a digital output and
it has already been connected to the TX-NR801/TX-
NR801E, you cannot connect the digital input of the
device to the DIGITAL OUT jack of the TX-NR801/TX-
NR801E simultaneously.
Note:
The output from the DIGITAL OUT jack of the
TX-NR801/TX-NR801E is only the digital signal input
to the DIGITAL IN jack.
The TX-NR801/TX-NR801E is equipped with AC mains
outlets for connecting the power cords from other devices
so that their power is supplied through the TX-NR801/
TX-NR801E. By doing this, you can leave the connected
device turned on and have the STANDBY/ON button on
the TX-NR801/TX-NR801E turn on and off the device
together with the TX-NR801/TX-NR801E.
The shape, number, and total capacity of the AC
outlets may differ depending on the area of purchase.
Caution:
Make sure that the total capacity of the components connected
to the TX-NR801/TX-NR801E does not exceed the capacity
that is printed on the rear panel (e.g., TOTAL 120W).
Connecting a Turntable (PHONO)
Connecting a Cassette Tape Deck,
MD Recorder, DAT Deck, or CD
Recorder (TAPE)
AUDIO
VIDEO
S VIDEO
MONITOR
OUT
R
L
IN
IN
IN
IN
IN
ZONE 2
DVD
VIDEO 1
VIDEO 2
VIDEO 3
VIDEO 4
AUDIO
VIDEO
S VIDEO
COMPONENT
VIDEO
Y
P
B
PR
OUTPUT
INPUT 1
Y
P
B
PR
INPUT 2
Y
P
B
PR
R
L
OUT
OUT
OUT
PHONO
DIGITAL
IN
PRE OUT
DIGITAL
OUT
OPT
OPT
2
1
2
1
2
3
FRONT
SUB
SURR
R
L
AUDIO
R
L
CD
TAPE
R
L
AUDIO
1
3
GND
SURR
BACK/
ZONE 2
IN
OUT
COAX
R
L
MULTI
CH
INPUT
FRONT
SUB
SURR
SURR
BACK
CENTER
RL
R
L
AM
FM
75
CENTER
ANTENNA
IN
IN
PHONO
IN
RL
AUDIO
Ground wire (earth)
AUDIO
VIDEO
S VIDEO
MONITOR
OUT
R
L
IN
IN
IN
IN
IN
ZONE 2
DVD
VIDEO 1
VIDEO 2
VIDEO 3
VIDEO 4
AUDIO
VIDEO
S VIDEO
COMPONENT
VIDEO
Y
P
B
PR
OUTPUT
INPUT 1
Y
P
B
PR
INPUT 2
Y
P
B
PR
R
L
OUT
OUT
OUT
PHONO
DIGITAL
IN
PRE OUT
DIGITAL
OUT
OPT
OPT
2
1
2
1
2
3
FRONT
SUB
SURR
R
L
AUDIO
R
L
CD
TAPE
R
L
AUDIO
1
3
GND
SURR
BACK/
ZONE 2
IN
OUT
COAX
R
L
MULTI
CH
INPUT
FRONT
SUB
SURR
SURR
BACK
CENTER
R
L
R
L
AM
FM
75
CENTER
ANTENNA
IN
IN
IN
RL
TAPE
OUT
1
DIGITAL
OUT
OPT
2
DIGITAL
IN
OPT
AUDIO
RL
AUDIO OUT
RL
AUDIO IN
DIGITAL
OUT
OPT
DIGITAL
IN
OPT
Cassette tape deck, MD recorder,
DAT deck, or CD recorder
MD recorder, DAT deck,
or CD recorder
Connecting the Power Cords from
Other Devices
AC OUTLETS
AC
120
V 60
Hz
SWITCHED
TOTAL 120W 1A MAX.
AC
OUTLETS
AC 230
-
240
V 50
Hz
SWITCHED
TOTAL 100
W MAX.
AC 230
-
240
V 50
Hz
SWITCHED 100W MAX.
AC OUTLET
AC
OUTLET
SWITCHED
100W MAX.
European and some
Asian models
USA and Canadian
models
Worldwide model Australian model
24


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Onkyo TX-NR801 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Onkyo TX-NR801 in the language / languages: English as an attachment in your email.

The manual is 5,3 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info