601422
9
Zoom out
Zoom in
Previous page
1/156
Next page
9
Before Using the RDC-7.1
Notes:
The supplied batteries should last for about six
months, although this will vary with usage.
If the remote controller doesnt work reliably, try
replacing the batteries.
Dont mix new and old batteries, or different types of
batteries.
If you intend not to use the remote controller for a
long time, remove the batteries to prevent possible
leakage and corrosion.
Expired batteries should be removed as soon as
possible to prevent damage from leakage or
corrosion.
To use the remote controller, point it at the RDC-7.1s
remote control sensor, as shown below. The RDC-7.1s
[Standby] indicator ashes while a signal is being
received from the remote controller.
Notes:
The remote controller may not work reliably if the
RDC-7.1 is subjected to bright light, such as direct
sunlight or inverter-type uorescent lights. Keep this
in mind when installing the RDC-7.1.
If another remote controller of the same type is used
in the same room, or the RDC-7.1 is installed close to
equipment that uses infrared rays, the remote
controller may not work reliably.
Dont put anything, such as a book, on the remote
controller, because the buttons may be pressed
inadvertently, thereby draining the batteries.
The remote controller may not work reliably if the
RDC-7.1 is installed in a rack behind colored glass
doors. Keep this in mind when installing the
RDC-7.1.
The remote controller will not work if theres an
obstacle between it and the RDC-7.1s remote control
sensor.
(RC-555M only) You can set the transmission signal
format to infrared (IR), or radio frequency (RF) for
use with the optional RF Receiver. This is useful
when, for example, the RDC-7.1 is installed in a rack
or is not in line of sight of the remote controller.
To select AMP mode, press the scroll wheel. AMP
appears on the display.
Installing the Batteries
1
To open the battery compartment, press
the small hollow and slide off the cover.
2
Insert the three supplied batteries (AA/R6)
in accordance with the polarity diagram
inside the battery compartment.
3
Put the cover onto the remote controller
and slide it shut.
Using the Remote Controller
30˚
30˚
Approx. 16 ft. (5 m)
Remote control sensor
Standby indicator
RDC-7.1
Getting Started
9


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Onkyo RDC-7.1 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Onkyo RDC-7.1 in the language / languages: English as an attachment in your email.

The manual is 12,41 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Onkyo RDC-7.1

Onkyo RDC-7.1 User Manual - German - 156 pages

Onkyo RDC-7.1 User Manual - Dutch - 156 pages

Onkyo RDC-7.1 User Manual - French - 156 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info