371088
81
Zoom out
Zoom in
Previous page
1/88
Next page
81
:
ENTER
5 to 15 cm
(2 to 6 inches)
Buttons that cannot be programmed.
SEND/LEARN
indicator
MODE
buttons
Programming the commands of remote
controllers for other devices into the
remote controller
When programming the commands of another remote
controller to the RC-484M remote controller, you must first
decide under which MODE button you want the commands to
be linked. In general, you will select the MODE button that
corresponds to the component you are programming.
After programming which MODE button to use, you will then
transfer the separate commands from the other remote
controller over to the RC-484M remote controller one at a
time. Each command is then programmed to a different button
on the RC-484M remote controller. Any button is
programmable for this step except for the six MODE buttons
(DVD, CDR, TAPE/MD/HD, AUDIO, VCR, TV).
Even after the commands have been memorized, keep your
old remote controller in a safe place. If for some reason the
commands are lost (e.g., when the batteries run down), it will
be necessary to memorize them once again.
Place the remote controller and the
remote controller for the other
device facing each other at a
distance of 5 to 15 cm (2 to 6
inches) apart.
While pressing and holding down
the desired MODE button on the
remote controller, press the ENTER
button and then release both
buttons.
When you press and hold down the MODE
button, the SEND/LEARN indicator lights.
When you press the ENTER button, the
lamp turns off. When you release the
buttons, the lamp lights again.
Press and release the button on the
remote controller to which you want
to transfer the next command.
You may select any button but the eight
ones indicated in the figure below. When
you press the button, the SEND/LEARN
indicator turns off. When you release the
button, the indicator lights again.
If you press the wrong button by mistake,
press that same button again. The SEND/
LEARN indicator flashes twice, and the
remote controller exits the programming
mode.
1
2
3
81


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Onkyo dr s 2 2 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Onkyo dr s 2 2 in the language / languages: English as an attachment in your email.

The manual is 4,63 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info