568983

Olympia Protect serie Accessories Manual

18
Zoom out
Zoom in
Previous page
1/37
Next page
Wireless Motion Detector
G
18
Scope of Delivery
Wireless motion detector 1
Batteries 3 x AA batteries
Assembly material Screws, dowels
Wall bracket 1
Instruction manual 1
Please check the contents of the package carefully. If anything is missing or has
been damaged during transport, DO NOT put the water leak detector into opera
tion!
Installation
Recommended Installation Locations
The installation location must be within transmission range of the base unit of
the Protect series alarm system.
The installation location of the wireless motion detector must be selected so that
an intruder must pass through the area monitored.
An optimal installation location is directly in a corner, between 2 and 3 meters
above the floor at an angle of 14 degrees. The possible direction of movement of
an intruder should be frontal towards the wireless motion detector.
Inappropriate Installation Locations
The area monitored by the wireless motion detector should not be obstructed by
objects (e.g. furniture, curtains, etc.).
Avoid locations in which there is a quick temperature change in the area moni
tored; near an air-con unit or heater, for example.
No pets should have access to the area to be monitored by the wireless mo
tion detector when the alarm system is armed.
Wall Installation
Ჰ
WARNING!
• Risk of serious injuries through damaging cables or lines!
Ჾ During installation, pay attention to the possibility of cables running in
the walls. We are not deemed liable for installation errors. If in doubt, con
tact a specialist!
The wireless motion detector is provided with a wall bracket which can be mount
ed on a wall as well as on a ceiling.
1. Screw the wall bracket to the chosen installation location using two screws
approx. 45 mm apart. (It may be necessary to drill the two holes first and then
insert dowels in which to tighten the screws, depending on the properties of the
wall.) Refer to Fig. 3.
2. Hook the wireless motion detector over the pins on the wall bracket and pull the
housing downwards a little.
Inserting the Batteries
1. Use a screwdriver to loosen the screw in the battery compartment cover on the
rear side of the wireless motion detector.
2. Remove the battery compartment cover.
3. Insert the AA batteries in the battery compartment (pay attention to correct
polarity). Refer to Fig. 2.
4. Replace the battery compartment cover.
5. Replace and tighten the screw.
… 18 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Olympia Protect serie Accessories at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Olympia Protect serie Accessories in the language / languages: English as an attachment in your email.

The manual is 1,09 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Olympia Protect serie Accessories

Olympia Protect serie Accessories User Manual - German - 40 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info