568983
35
Zoom out
Zoom in
Previous page
1/37
Next page
Outdoor Siren
G
35
Assembly material Screws, dowels
Instruction manual 1
Please check the contents of the package carefully. If anything is missing or has
been damaged during transport, DO NOT put the outdoor siren into operation!
Installation
Installation Steps
WARNING!
Risk of serious injuries through damaging cables or lines!
During installation, pay attention to the possibility of cables running in
the walls. We are not deemed liable for installation errors. If in doubt, con
tact a specialist!
Proceed as follows to assemble the outdoor siren:
1. Ensure that there are no electric cables, gas or water pipes near the installation
location.
2. Drill two holes, approx. 37 mm apart, at the intended installation location and
insert the screws supplied using dowels. The screw heads must project about
3 mm from the wall so that the outdoor siren can be hooked on them.
3. Loosen the screw in the battery compartment cover using a screwdriver and
insert the batteries supplied in the outdoor siren, paying attention to correct polari
ty (Fig. 1).
4. Register the outdoor siren on the base unit of the alarm system (refer to Regis
tering the Outdoor Siren on the Alarm System).
5. Slide the battery compartment cover on the outdoor siren and tighten the screw
in the battery compartment cover tight.
6. Hook the slots in the rear panel of the outdoor siren on the screws installed in
the wall in Step 2.
Registering the Outdoor Siren on the Alarm System
The outdoor siren must be registered on an alarm system from the Protect series.
1. Select the
Register menu option on the alarm system.
2. Remove the batteries from the outdoor siren's battery compartment.
3. Replace the batteries in the outdoor siren. As soon as the last battery is insert
ed in the outdoor siren, you will hear a short acoustic signal indicating registration
on the base unit.
4. When the message
Speaker followed by a number appears in the alarm sys
tem display, registration on the alarm system was successful.
5. If the outdoor siren has not been registered successfully, remove one of the
batteries and then replace it.
6. Change the entry in the alarm system as necessary.
To configure the alarm system, please refer to the manual related to the
alarm system.
Technical Data
Weight: 198 g
Dimensions (W x H x D): 92 x 138 x 49 mm
Frequency: 868 MHz
Batteries 4 x AAA batteries
35


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Olympia Protect serie Accessories at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Olympia Protect serie Accessories in the language / languages: English as an attachment in your email.

The manual is 1,09 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Olympia Protect serie Accessories

Olympia Protect serie Accessories User Manual - German - 40 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info